In this video we show you everything you need to know about the Geek Vape Aegis Legend 2 Kit, you can buy this kit from The Vape Shop www.thevapeshopessex.co.uk
Seriously, I started around the same time. knowledge truly is power, and this knowledge gave me the power to stop smoking, which I never thought I'd do.
OMG!!! Thank you so much! I accidentally turned down the brightness and could not figure out how to turn the brightness back up. It's all good now! thank you again!!!
Thanks! My model tank is slightly different as the mod box nor tank box nor coil pack came with the little wrench. I figured out I can just pop it out with my fingers but still... Also no tabs to line up the coil when putting back into the tank. Kind of weird. I've had 2 Aegis geekvapes and this is a bit different. Still thanks to your vid I was able to figure it out much appreciated from the US 🙂👋
You dont need to prime the cotton, this is why in the directions it says to wait 5 minutes before using after filling. You also DO NOT want to prime the cotton after you have already filled the container. That's how you make a mess.
Hi can you just fill tank leave vape liquid to slowly absorb over five to ten minutes?,instead of puuting liquid in and on sides which you did? Thank you.
Seems a ridiculous oversight, but the instruction manual doesn't include anything about charging nor did you cover it in the video. The reason for the question is my previous geekvape during charging the battery indicator shows on the screen during charging and the animation stops when it is fully charged. Just taken delivery of the L200, and plugging in, the battery symbols show briefly on the screen, and the animation, but doesn't stay on. Pressing the main button, the animation reappears briefly, then screen switches off again. Currently don't know if it is still charging or how to know when it is fully charged.
I'm having problems with the batteries, when i put them in it wont close off , the problem is the far one where the tip of the battery is up, makes the cap unable to close, how would i sort this?
Greetings 🖖 good sir I’m struggling to find replacement seals for the Zeus legend 2 tank. Would a generic oring mixed set do same job. Or could you point me in the right direction as to which rings to use and best place to get them. Much obliged.
Does anyone know how to change the ohms on the geek vape been searching all over the internet seems I can't find a direct response someone that has a little more knowledge please help
I received my L200 and despite instructions (which don't say a thing about the small pry tool). If not for your clip I wouldn't have had a clue to remove or the Priming of the coil process that is also not mentioned in the instructions..🫡thanks for this. But can you tell me what the seals in the bag are for, please.
I just bought the Legend 2 and I had Aegis X before that, and the guy in the vape-shop told me that I could use the old Cerberus tank for the Legend 2 if I wanted to. I've heard that the Zeus tank that came with my Legend 2 is better though, so I'm gonna try it out first. :) But I know that you should be able to if it was a Cerberus tank anyways. :)
Hi there I just bought this device today. For the standard tank do I need to do anything with the temp controls or is that setting more for the RTA tank. Awesome video by the way. Many thanks. Kev.
I think I regret buying this product already... I'm trying to put the bottom part back on as you did in the video, but the o-ring keeps popping out when I try to screw, so I have to push it down again with my fingers, then I have no idea how you manage to screw it on like you did in the video? Mine won't, lol... Fuck...
I first started vaping back in 2014, and I swear if it weren't for these guides I would be completely lost lol.
SAME WITH ME!
Seriously, I started around the same time.
knowledge truly is power, and this knowledge gave me the power to stop smoking, which I never thought I'd do.
Thank you for being so thorough and quick. It's nice to find a video that you don't have to ffwl and rewind ffw and rewind.
OMG!!! Thank you so much! I accidentally turned down the brightness and could not figure out how to turn the brightness back up. It's all good now! thank you again!!!
Thanks! My model tank is slightly different as the mod box nor tank box nor coil pack came with the little wrench. I figured out I can just pop it out with my fingers but still... Also no tabs to line up the coil when putting back into the tank. Kind of weird. I've had 2 Aegis geekvapes and this is a bit different. Still thanks to your vid I was able to figure it out much appreciated from the US 🙂👋
Thanks bud I had been looking for instructions on changing the coil and your video saved me! You guys rock
U for got to tell them in menu setting if u hold the plus and mins u can change the colors
Thanks that was a big help unless I missed it there was sweet FA in the information booklet .
You dont need to prime the cotton, this is why in the directions it says to wait 5 minutes before using after filling.
You also DO NOT want to prime the cotton after you have already filled the container. That's how you make a mess.
i poured my vape juice down the center hole and made a strawberry scented mess in my moms car LOL
Hi can you just fill tank leave vape liquid to slowly absorb over five to ten minutes?,instead of puuting liquid in and on sides which you did?
Thank you.
Thank you so much this video helped me out a lot
Do I need to mess with any settings or can I just put my tank on and vape within the wattage range of the coil I'm using?
Where can u order or get batteries 🔋 from ordered 1 from amazon paid extra for batteries but none came
Seems a ridiculous oversight, but the instruction manual doesn't include anything about charging nor did you cover it in the video. The reason for the question is my previous geekvape during charging the battery indicator shows on the screen during charging and the animation stops when it is fully charged. Just taken delivery of the L200, and plugging in, the battery symbols show briefly on the screen, and the animation, but doesn't stay on. Pressing the main button, the animation reappears briefly, then screen switches off again. Currently don't know if it is still charging or how to know when it is fully charged.
Will the mod adjust to any tank put on it? All the numbers numbers under the wattage confuse me
What batteries did you use?
does this mean I can change the coil with fluid still in the tank?
Are u able to take it out without the spanner?
Mine keeps having juice leak into the very bottom like half the tank empties then the coil is drenched how do i fix
Make sure the coil is screwed in properly check o-rings to make sure they are intact
what is that liquid that you put in the spare coil?
Hi I need help. I can't open the bottom where I can change the coil. Any tips?
Is it supposed to come with batteries ?
Or is that sold separately
I'm having problems with the batteries, when i put them in it wont close off , the problem is the far one where the tip of the battery is up, makes the cap unable to close, how would i sort this?
You need to use flat top batteries not button top.
What liquid are you using in the clear container?
Greetings 🖖 good sir I’m struggling to find replacement seals for the Zeus legend 2 tank. Would a generic oring mixed set do same job. Or could you point me in the right direction as to which rings to use and best place to get them. Much obliged.
Is that the juice you put on the coil? And how (if possible) can i change the cotton inside the coil?
Yes I put a little bit of juice on the cotton on the inside of the coil and it is possible but no recommended
@@TheVapeShopEssex soo how long does one coil last? On average use? And it's a whole coin replacement everytime?
@@eurusson3762 a coil can last anything from a couple of days to a couple of weeks all depends on usage
@@eurusson3762 yes you would replace the coil every time
@@TheVapeShopEssex thanks brother, appreciate the effort
Where and what batteries do you get for thus pen as no matters came with it 💔💔💔💔💔💔 Thank you
Why prime it when it primes itself?
Where do I get batteries for it, why is your tank bigger than the 2ml? Why can't you just answer these
how many ohm did u use?
Cheers fella
Does anyone know how to change the ohms on the geek vape been searching all over the internet seems I can't find a direct response someone that has a little more knowledge please help
Ohms is a measurement of resistance of the coil. It can't be changed unless you change the coil.
You forget the black thing before you do it the last step 😂 i follow you 🤦🏼🤦🏼
I received my L200 and despite instructions (which don't say a thing about the small pry tool). If not for your clip I wouldn't have had a clue to remove or the Priming of the coil process that is also not mentioned in the instructions..🫡thanks for this. But can you tell me what the seals in the bag are for, please.
Can i be able to use the tank from the previous Aegis legend model?
I just bought the Legend 2 and I had Aegis X before that, and the guy in the vape-shop told me that I could use the old Cerberus tank for the Legend 2 if I wanted to. I've heard that the Zeus tank that came with my Legend 2 is better though, so I'm gonna try it out first. :) But I know that you should be able to if it was a Cerberus tank anyways. :)
Hi there I just bought this device today. For the standard tank do I need to do anything with the temp controls or is that setting more for the RTA tank. Awesome video by the way. Many thanks. Kev.
Hello hope you are enjoying your device , you don’t have to do anything regarding temperatures unless you want to run in temperature control mode.
@@TheVapeShopEssex could you advise which mode would be better to run it on. I’m still trying to get to grips with it. It’s a fantastic machine.
@@vikingkev what liquid are you using ?
@@TheVapeShopEssex absolution juice 70/30. Friend.
@@vikingkev run it in wattage what ohms is the coils ?
I got mine today, put batterys in and put on charge and the main screen is flashing very fast and still says low battery after having on charge
I think I regret buying this product already... I'm trying to put the bottom part back on as you did in the video, but the o-ring keeps popping out when I try to screw, so I have to push it down again with my fingers, then I have no idea how you manage to screw it on like you did in the video? Mine won't, lol... Fuck...
@GordiusKnot well that helped alot....I actually started to get a cramp in my hand from this very same problem. It's actually why came to this video
Change the O-ring. Fixed for me.
I have a big problem everything is good installed but the smoke that come out smell bad and not so much smoke u know the problem
Same as mine anoyying hey