You could achieved the same result if you used an angle bracket instead of the box tubing. I know your not done but i also think you should round off the corners off those other tabs that are close by the dump cylinders to give it a cleaner look. Also dont forget you need limitor straps installed on the dump stage, ive seen so many racks fall over where they dont install any. Just a piece of mind tho..
I agree with you on that, I didn’t think about it. Thanks for the tip! I won’t need limit strap’s since my dump doesn’t dump high like some, that’s when the weight of the bed + rack overtakes and fall’s back but I do agree, if you have a high dump you will need limit straps
a fresh vid hell yeah !!!!
The flat steel is going to flex a lot. I went with 1.5” square tubing
They make cylinders with side ports so you won’t scrape the fittings
Dude this is so cool to see
I remember the old vids and to see you fabbing a full dancing bed rack is insane
Big ups to you man
Thank you !
Looks nice bro 🔥
Thanks !
You could achieved the same result if you used an angle bracket instead of the box tubing. I know your not done but i also think you should round off the corners off those other tabs that are close by the dump cylinders to give it a cleaner look. Also dont forget you need limitor straps installed on the dump stage, ive seen so many racks fall over where they dont install any. Just a piece of mind tho..
I agree with you on that, I didn’t think about it. Thanks for the tip! I won’t need limit strap’s since my dump doesn’t dump high like some, that’s when the weight of the bed + rack overtakes and fall’s back but I do agree, if you have a high dump you will need limit straps