Extras and clarification for the Auto climb and Descend for Cruise mode

[@SILVIOFRANCO1]

This will be useful. I will full watch later. Thanks, Darren

[@MrD]

Thanks Silvio 👍🏻

[@North49RC]

In setting up a curve in OpenTX/EdgeTX using the slider as your input, it is always a good idea to add a center dead band. Even though most radios have a physical detent for center sometimes it is hard to find exact center when in flight, under the goggles, maybe in a higher stress situation, etc. Adding in a 5 point dead band on either side of center in the curve gives you a litlle play room to dial in center mid flight. Just a tip. Great vid Darren

[@MrD]

Great idea. I've noticed that some transmitters are better than others as far as the detent goes. But, I guess with the sliders it's a compromise anyway. Some glider pilots use a slider as the throttle. So a more subtle detent is better here.

[@North49RC]

@@MrD I know it works really well for a pan/tilt application. I would have issues with trying to find center even with a detent by over shooting a couple times before its dialed in. The dead band stops this back and forth movement, and even a slow down by 0.5-1 second smoothes it out too

[@M-H433]

Thankyou Darren.

[@MrD]

Thanks Mark

[@sleepingbearffg5008]

I nav made clear?? Lol Doing great job!