Nice video I put up new ip module for Cust existing panel. Status light on ip module is on and green But no link light. I tried swapping the ports from modem and cables is changed as well. Do you know if this could be firmware issue? At the moment it v 2.23
Hey mate, how do you use zones 9-16. When im trying to configure part alarm, it is only showing zones 1-8 even though all 16 are connected. (System was working fine but i had to default the settings and wasn't able to get this working again after defaulting)
@norsonproductions3519 from zone 1 to 8 you use 3k3 resistor and from zone 9 to 16 you use 6k8 resistor provided in the kit. Then in the programming section you enable zones one by one and give a dedicated function such as Delay, Instant, 24hr Aalrm and so on Thanks
@@hamed827 Hello, yes we have made it to this point but when we go into programming 3.1.1 we can only find zones 1-8 showing that we are able to enable or dedicate a function. We cant find how to get to zones 9-16
Hi Jose. Thanks for heads up, yes you are right. it has only one Relay (on board ) and 5 outputs. Output 6, 7 and 8 are Virtual. Warmest regards dear Jose 👍🏻✌🏻
Nice video
I put up new ip module for Cust existing panel.
Status light on ip module is on and green
But no link light.
I tried swapping the ports from modem and cables is changed as well.
Do you know if this could be firmware issue?
At the moment it v 2.23
Hey mate, how do you use zones 9-16. When im trying to configure part alarm, it is only showing zones 1-8 even though all 16 are connected. (System was working fine but i had to default the settings and wasn't able to get this working again after defaulting)
Hi, by default, zone 9 to zone 16 are Disabled. You need to program and enable,
@@hamed827 hello we have the same issue, we are not able to access Zones 9-16, I have no idea of how to enable these zones so we can programme them?
@norsonproductions3519 from zone 1 to 8 you use 3k3 resistor and from zone 9 to 16 you use 6k8 resistor provided in the kit. Then in the programming section you enable zones one by one and give a dedicated function such as Delay, Instant, 24hr Aalrm and so on
Thanks
@@hamed827 Hello, yes we have made it to this point but when we go into programming 3.1.1 we can only find zones 1-8 showing that we are able to enable or dedicate a function. We cant find how to get to zones 9-16
There is only one relay on board the rest are outputs as voltage out but not relays. Dont mix the terms
Hi Jose. Thanks for heads up, yes you are right. it has only one Relay (on board ) and 5 outputs. Output 6, 7 and 8 are Virtual.
Warmest regards dear Jose 👍🏻✌🏻