Some helpful advice when fitting out of square cuts. Put a tack weld on the long side ( the direction it needs to lean). The tack itself will draw it that direction itself. If still not enough to be square. Tap it over or pull it square carefully. It should hold itself. Then tack the opposite side. If done in the middle of each side, you can still square it on the other 2 sides. Not sure if I made sense or not. Just thought I’d share some knowledge
you need to make a sword on camera. I don't think I have seen you make one of those yet except your forged in fire show. How is my knife build coming along?
I may be a little late to the game, but you don’t want to heat parks 50. It’s maximum operating temperature should never go above 120f. Unless the temperature of your oil is significantly under 70f, there is no need to heat it like you would with canola oil
Thank you for all your videos!!! I have learn so much from your videos!! Thank you making all these videos!
You bet, thanks!
Some helpful advice when fitting out of square cuts. Put a tack weld on the long side ( the direction it needs to lean). The tack itself will draw it that direction itself. If still not enough to be square. Tap it over or pull it square carefully. It should hold itself. Then tack the opposite side. If done in the middle of each side, you can still square it on the other 2 sides.
Not sure if I made sense or not. Just thought I’d share some knowledge
Thanks for the tip!
I like how you added feet on all four corners so that you didn't have to grind the center weld off!
Thanks! Seemed to work okay
you need to make a sword on camera. I don't think I have seen you make one of those yet except your forged in fire show.
How is my knife build coming along?
Hi Steve, yes I'll have do that sometime. Your knife is the next one I'll be starting, actually!
I may be a little late to the game, but you don’t want to heat parks 50. It’s maximum operating temperature should never go above 120f. Unless the temperature of your oil is significantly under 70f, there is no need to heat it like you would with canola oil
👍🏻
I'm never first to comment....... 😥
Do u have an email?
Yes sir it's in the about section on the channel here