Skynetic Swift Assembly | Motion RC
Вставка
- Опубліковано 19 вер 2024
- The Skynetic Swift EPP is a 3D flyer that can penetrate through moderate winds while performing show-stopping 3D maneuvers with ease. Product link & Flight video link below:
Skynetic Swift: www.motionrc.c...
Flight Video: • Skynetic Swift 3D Flig...
Motion RC Merch available here: motion-rc.crea...
Join this channel to get access to perks:
/ @motionrc
Got mine and it came with a few things assembled already - the large CF tubes and supports were already glued into the fuse (not very neatly, unfortunately) as well as the landing gear and motor mounts. Also wound up with 2 CF rods about 1.5 mm x 8 in. and I have no idea what purpose they serve. The slot for the wing was also cut at a bit of an angle rather than 90 degrees.
Other than these inconsistencies, the kit arrived with everything fitting together quite nicely, I usually build from scratch so this was a treat!
Do you need servo wire extensions for the rudder and elevator? You never mentioned that.
Why didn't you glue the wing halves together??
Some work to put together but looks a lot easier than most profile foamies. Think I will make one my Xmas present to myself. I am with you on flying these kinds of planes hand launched.
PLEASE DO THE SKYNETICS YAK 1100MM Build video
Why didn't u show the rudder rod install just to show us noobs?
Also the online manual shows the elevator rod to the bottom
What a piece of junk....it flys like crap