Concealed shower valve - Thermostatic cartridge (brass): maintenance, replacement and calibration
Вставка
- Опубліковано 10 лип 2014
- This easy to follow video explains the maintenance, replacement and calibration of the thermostatic cartridge on a Concealed Thermostatic Shower Valve.
If you'd like to learn more about the benefits of thermostatic cartridges in the bathroom, check out our handy article, Spotlight on: Thermostatic Showering: www.vado.com/spotlight-thermostatic-showering
If you'd like to view our extensive range of showering products, visit www.vado.com/sub-categories/showering
I've learnt so much. Firstly that you can isolate with the two small screws! Then the hex holding nut, and finally that you can take that whole unit out!!! Now I have a hole in the wall, but at least the drop has finally stopped.
Excellent. A simple job but your video gave me the extra clarity I needed. Thank you.
Note that the older version 2011 looks exactly the same but has no grub screw.
When unscrewing it turned partly and got stuck hard, harder than the force I dared apply. Wd40 around the thread and left it overnight. Trying again the next day it started to give and then unscrewed.
where could we buy the replacement part for latoscana in this video
I followed every step but when I loosened the actual valve it seemed to me that only the front portion came off. I noticed on your video the valve cartridge shows it covered with a screen. As it looks when you first install. I say this because shower fixture still has the round screen portion in shower fixture. Is this right or am I looking at a different type or set up? I have a Hudson Reed Shower fixture. Any direction would be appreciated thank you
No sealant behind the faceplate? Mine was properly stuck on with sealant.
Nice, practical video.
The mixers seem to often clog up with calcium. I fixed mine by dismantling and greasing with silicon grease a while back, still good. Not sure of the make but for interest here’s the fix video to fix it nearly free (just some grease needed): ua-cam.com/video/k8Aiem2kOgI/v-deo.html
what does the temperature stop ring do? Ive had mine reassembled but this hasnt been put back on..
Mike Newman ermmm stops you being scolded...
Removed the grub screws but cannot get the tap off at all the shower one comes off but the thermostat one will not budge
Dan M same issue. I can’t figure out how to remove the tap from the thermostat
Same problem. The video shows the thermostat being easily withdrawn but mine won't budge.
No I like to see if the cartridge itself can be repaired. I have the problem that there is a sticking point somewhere inside . And it seems inposible to find the right replacement cartridge .
how to remove grolta 4 way shower valve temperature cartridge dats hard to remove
Can I get a web link to this shower as I would like to buy this model.
or just the name of the shower will be fine ?
That is going to be a nightmare after fifteen years of use. The retaining screws will be frozen, the face plate retaining rings will be frozen, you'll scratch the face plate with your wrench as you try to loosen them, you'll leave wrench teeth marks in the rings...
*
What's 🤔🫣 mi no entender 🤷🏽♂️