First Project BT30 ATC Spindle on my DIYCNC
Вставка
- Опубліковано 15 вер 2024
- DIY Aluminium CNC
HGR20 Rails with HGH20CA Z1 Blocks on all Axis
C5 SFU1605 with Dualnut on all Axis
4,5kw BT30 ATC Spindle with Fuling VFD
Nema 23 CL Stepper on all Axis
LinuxCNC Probe_basic with Mesa 7i76e Ethernet Card
Amazon Wishlist: www.amazon.de/...
Been following your videos. Anticipating my MR1 machine from Langmuir.. Getting excited.. Your machine is pretty stout. Love the new spindle.
Thank you i´m working for much more Stability
Need to tram it or something.
Very nice design! (Out of interest, does it get red hot with a candle in it?!)
No, works fine with a candle.
sehr sehr nice!
was waren das für schnittdaten beim planfräsen? thx
müssten 10000rpm gewesen sein bei 1500mm/min.
Stell die Messer des Messerkopfs mal in einem leichten Winkel zur Werkstück Oberfläche, also nicht parallel. Dann sollte die Oberfläche etwas schöner werden.
Falls es funktioniert. Werde es testen.
wie genau meinst du das? sry wenn es eine DAU Frage ist, bin aber Hobbyist
@@bonsaicnc die Schneide nicht parallel zum Werkstück sondern mit einem Kleinen Winkel, ähnlich wie bei Fischschwans Fräsern, nur nicht so stark.
show de bola 👍
what is your probe brand/model? I'm looking for one.
DIG3DLPM
can u link on AliExp or ebay the 1st face mill in video?
Hello please see at my another videos (comments).
Hi, I have a very similar setup, what was your feeds and speeds please for the fly cutter and 2flute?
Hello, for the Facemill i´ve used 10000rpm, 2000mm/min and 1000mm/min for finish.
for the 10mm 2 Flute Endmill i´ve used 16000rpm at 2700mm/min Feedrate for finish i´ve used 24000rpm at 1500mm/min.
@@cnc_andi3294 Geez, are you running AC servo motors ?
@@besssam now im using dc nema23 cl stepper motors
@@cnc_andi3294 interesting, I use those also. I have been been ultra conservative fearing if the motors loose step. Perhaps I should dial up a little. right now the max feed is 1200mm/min
@@besssam You have to try that, I don't know your machine.
But normally there is more to it than that. I have 6000mm/min. in G0.
Operate the motors with a 36V power supply.
But it also depends on your machine
What model and diameter of this mill used in surface ?
Hello, It's a 35mm 3Flute Facemill from Fraiser
@@cnc_andi3294 Many thanks!
@@jgtools you are welcome ;)