Adafruit CLUE component tester identifying a panoply of components

Поділитися
Вставка
  • Опубліковано 3 гру 2024

КОМЕНТАРІ • 2

  • @kevinwalters2076
    @kevinwalters2076  3 роки тому

    00:06 Nothing
    00:21 Solid core conductor
    00:36 1k resistor (979 ohms on multimeter)
    01:02 10k resistor ** (9.89k)
    01:17 47 resistor ** - 54 shown, 56 on colour bands, slightly wrong on nearest match
    01:32 300 resistor - 302 shown , 330 on colour bands due to E12 matching
    01:45 IN5408 silicon power diode
    01:58 Germanium diode
    02:13 Schottky diode
    02:27 Zener diode 3.3V
    02:42 Red LED **
    02:57 Orange LED **
    03:12 Yellow LED **
    03:27 Green LED **
    03:42 Blue from RGB LED **
    03:56 PN junction from a BC337 NPN transistor **
    04:11 NPN across collector emitter **
    04:26 Ceramic capacitor 100nF
    04:40 Mullard "tropical fish" polyester capacitor 220nF
    04:55 Electrolytic capacitor 10uF - salvaged from an old, broken PC power supply
    05:09 Electrolytic capacitor 470uF ** - has very low impedance at test frequency
    05:22 Small DC motor ** (9.98mH on cheap LCR tester) - inductance too low
    05:54 Relay coil 230 ohm (520mH)
    06:19 One primary from a 20VA mains transformer
    06:35 Both primaries
    06:48 Small piezo speaker
    07:02 10k potentiometer
    Values in brackets are from independent measurements.
    Items marked ** are from Kitronik Inventor's Kit