Hi, great feature for drawing but i would like the feature to add the circles around the edges in the cam software, so that the 90° corners get really sharp and not rounded. I mean the feature where it first runs out the edge, makes a circle and then enters the edge again to make it sharp😉
And where can i set the delay for the wait time for arc ok value becaus sometimes i get the arc ok error because my plasma cutter has a inconsistent delay between the start relay closing and the actual plasma arc starting
@@proma-elektronika3142 Thank you very much for your effort you put into your software and to really go into the customer wishes to try to make them work. 😍
The version I have does not have the feature "snap to tangent of arc". It ends at "snap to middle of a edge" the program came downloaded on my stvcnc plasma table I purchased in august this year 2021. any help or suggestions??
Well done, writing drafting software is satisfying. I worked as a programmer on Autocad back in the 1980's
Hi, great feature for drawing but i would like the feature to add the circles around the edges in the cam software, so that the 90° corners get really sharp and not rounded. I mean the feature where it first runs out the edge, makes a circle and then enters the edge again to make it sharp😉
You could program it so that it detects edges with no radius and a angle between 20° and 340° (for example)
And where can i set the delay for the wait time for arc ok value becaus sometimes i get the arc ok error because my plasma cutter has a inconsistent delay between the start relay closing and the actual plasma arc starting
@@markusk.488 i thinked about corners, but at this moment haven't good idea.
About arc time. I will try add it tommorow.
@@proma-elektronika3142 Thank you very much for your effort you put into your software and to really go into the customer wishes to try to make them work. 😍
nice job!!!
The version I have does not have the feature "snap to tangent of arc". It ends at "snap to middle of a edge" the program came downloaded on my stvcnc plasma table I purchased in august this year 2021.
any help or suggestions??