Great way to destroy your axle(just like you did :P). If you have bearing separator AND bearing puller then just simply hook puler to the separator. If you have only separator just clamp it like you did and then use 2 screws, and ~10mm steel bar to push the axle. Separator have 2 vertical holes, one on each side - use as large screws as possible. You need to drill 2 holes in steel bar in correct distance to push that axle. If you don't have separator / puller you can use long socket and hammer, but please use at least copper coin on top of axle to not destroy it like on this video.
Super Job , ich hab ein PWS 620 , das was Sie repariert haben , ich meine die Kugellager ist defekt die mit Getribe (abstands metal ist kaputt und die kugellagern die bleiben alle zusammen .
Great way to destroy your axle(just like you did :P). If you have bearing separator AND bearing puller then just simply hook puler to the separator. If you have only separator just clamp it like you did and then use 2 screws, and ~10mm steel bar to push the axle. Separator have 2 vertical holes, one on each side - use as large screws as possible. You need to drill 2 holes in steel bar in correct distance to push that axle. If you don't have separator / puller you can use long socket and hammer, but please use at least copper coin on top of axle to not destroy it like on this video.
many thanks for your help. now I can repair mine with same problem. thank you so much- renato Italy
You are welcome.
Muchas gracias por el video es de gran ayuda Dios lo vendiga
Thanks so much it worked 👍🏾
Техника ,на высоком уровне разборки ушм блогадарю, учус.
the gear housing, can fix other brand ?
Ok! Muito bom mesmo! Valeu 👍👍
can use any type of greese oil ?
No, a special grease is specified in the operating instructions.
Ótimo trabalho parabéns 👍👍
Muito obrigado.
You need to put a little more grease
Thanks for the tip.
Super Job , ich hab ein PWS 620 , das was Sie repariert haben , ich meine die Kugellager ist defekt die mit Getribe (abstands metal ist kaputt und die kugellagern die bleiben alle zusammen .
Thanks Man!
golpear directamente el eje para que salga no es algo tecnico, ya que deforma la punta del eje, si se cambia la corona se debe cambiar el rodamiento
Where you got this gear
Hey, Bosch has a very good homepage where you can reorder almost every part.
@@cyberbunny100 website konsi hi
Destruido el eje por los golpes, bruto... tendrías que usar un punzón o un extractor de ganchos.
।।
🎉ট।😊
wrong fitting