How to: Replace a Bad Water Temperature Sensor on your pool heater - Easy DIY

Поділитися
Вставка
  • Опубліковано 29 жов 2024

КОМЕНТАРІ • 15

  • @detkie
    @detkie 5 місяців тому +2

    Thank you! I was able to fix my heater by following these steps…this is the best video on this topic for AquaCal heaters.

    • @MikeZimmermanOfficial
      @MikeZimmermanOfficial  5 місяців тому

      Appreciate you watching, glad it helped! Pretty straight forward and simple for a diy job.

  • @kenbrown8186
    @kenbrown8186 4 місяці тому +1

    Thanks for taking the time to post this.

  • @lisakunish936
    @lisakunish936 5 місяців тому +1

    This is a super video! Thanks so much for putting this together, Mike. I need to do this weekend... Hoping I can find a direct replacement for my thermostat, but if not, it looks like a reasonably priced one could be obtained from Amazon.

  • @todda8695
    @todda8695 5 місяців тому +1

    Just ordered my sensor too. Thanks for the video. I know my pool isn’t 104 degrees as it says now . :-)

  • @DoctorBlankenstein
    @DoctorBlankenstein 4 місяці тому +1

    Did the repair work? My sensor is reading too high as well, but it is also not turning off when it goes beyond its set temp. Think it's the sensor... ? Or maybe control board?

  • @HEAVENLYTUNESDJANGEL
    @HEAVENLYTUNESDJANGEL 4 місяці тому +1

    AQUACAL doesn’t sell the og part the heater?
    Mines take for ever to get to the set temperature. Example it shows 82 or 84 and i set it for 89 or 90.
    Hot water is coming out but not moving the temperature on display.
    My salt generator will show the actual temp 89 or 90.