if i connect one analog modulation laser and one ttl modulation laser with pangolin fb3 in serial (shared control),how can i control the independently?i see the two fixtures in the program and then choose which i want to control?thanks.
So if I want to run say 4 lasers, I would need 4 of the FB3QS hardware pieces? Can Beyond or Quickshow allow for doing 4 independent shows running in sync?
Realizing this was asked a while back, yes, you'd need a separate FB3 for each laser you want to have independent control. If you are looking at four lasers, you might want to consider the Unity with FB4 built in. You can daisy chain the network cable and address them all individually on the single cable. You would not use ILDA control in that instance.
if i connect one analog modulation laser and one ttl modulation laser with pangolin fb3 in serial (shared control),how can i control the independently?i see the two fixtures in the program and then choose which i want to control?thanks.
So do these lasers not have DMX address ability or channel mode? also are they compatible with other lighting softwares?
if you daisy chain 2 of these lasers together, is it possible to invert the signal from one to create a symmetrical effect?
Yeah you can! The size dial goes negative as well.
So if I want to run say 4 lasers, I would need 4 of the FB3QS hardware pieces? Can Beyond or Quickshow allow for doing 4 independent shows running in sync?
Realizing this was asked a while back, yes, you'd need a separate FB3 for each laser you want to have independent control. If you are looking at four lasers, you might want to consider the Unity with FB4 built in. You can daisy chain the network cable and address them all individually on the single cable. You would not use ILDA control in that instance.
@@jstamets Thanks for the reply! I went with 2 Q3 6w's and a 10w Q3. Just running the 6w's mirrored. Thanks!