thank u very much for the video,very helpful i did the same thing as in the video and my hydraulic steering isnt working properly(i have change one sector shaft because the adjustment place was broken) i putted the sector shafts in timing i did everything, i dont know what to do anymore, i have inspected the power steering pump and replaced it with a new one and still doesnt work,what do u suggest to do please??
Tip .... The manual says to insert the central spool with it's internal (identification) groove uppermost (steering wheel side) of the control valve. (My understanding. Please verify to your own satisfaction.)
How did you get the sector shafts out? Does the inspection plate have to come off in order to slide it out? And do you have to take both the back and front off in order to get the ball screw nut out?
All I had to do was remove the steering wheel and the upper portion of the steering column to get the orbital valve out. Worst part was getting the dash and all the sheet metal out of the way.
Great video! Thanks for sharing. I would like to see the steering shaft and what wear it had.
thank u very much for the video,very helpful i did the same thing as in the video and my hydraulic steering isnt working properly(i have change one sector shaft because the adjustment place was broken) i putted the sector shafts in timing i did everything, i dont know what to do anymore, i have inspected the power steering pump and replaced it with a new one and still doesnt work,what do u suggest to do please??
Good job on video got a steering column to do today and top lid pump
Hope this helps!
Tip .... The manual says to insert the central spool with it's internal (identification) groove uppermost (steering wheel side) of the control valve. (My understanding. Please verify to your own satisfaction.)
Great video. So many times the steering wheel shaft is worn and pitted where it goes on the upper shaft seal causing it to leak also....
I suspected this one to be that way, would've made a good video to weld up and turn back down!
Where did you find your seals and o-rings? Thanks for your time.
eBay!
How did you get the sector shafts out? Does the inspection plate have to come off in order to slide it out? And do you have to take both the back and front off in order to get the ball screw nut out?
All I had to do was remove the steering wheel and the upper portion of the steering column to get the orbital valve out. Worst part was getting the dash and all the sheet metal out of the way.
@@arichindustries so you left the shaft in the tractor ok i got you. Thanks anyway for the reply
Deutsch