Socomec ATyS p Programming Source One (Mains) to Switch Position II | NHP
Вставка
- Опубліковано 22 сер 2024
- Programming a Socomec ATyS p to read source one is terminated to switch position two. This is useful for applications where source one power is not feed to the switch postion one terminals. Switch position one is the front set terminals and switch position two is the back set of terminals.
The full manual can be sourced from the below link. www.socomec.co...
This video is aimed at competent persons. Always refer to the original documentation when installing/commissioning. Under no circumstances shall NHP be responsible or liable in any way for any content, including but not limited to errors or omissions in the content, or for any loss or damage of any kind as a result of any content communicated in this video by NHP.
In no event shall NHP be liable for special, indirect, or consequential damages or any damages whatsoever resulting from the loss of use, data or profits arising out of or in connection with the availability, use of performance of any information communicated in this video. Due to factors beyond the control of NHP, it cannot guarantee against improper use or unauthorized modifications of this information.
NHP assumes no liability for property damage, or injury incurred as a result of any of the information contained in this video.
Use this information at your own risk. NHP products are for professional use only and NHP recommends safe practices as such, please consult a professional for any procedures or tools seen or implied in this video.
Due to factors beyond the control of NHP, no information contained in this video shall create any express or implied warranty or guarantee of a particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not NHP.
Hello sir can we program atys p with pc laptop trough rj 45 cable with easy config ?
correction switch get stuck between 0-1