Side notes: -Don’t plant seeds until your planter is at least 3000ml full of water. -1 Sprinkler is enough for 5 boxes max. If you have 4 planters you don’t need 2 sprinklers. But 1 light is only enough for 4 planters so if you have 5 planters on one sprinkler you’ll need 2 lights -Because of differences in water consumption, berries are most efficient grown in a 2x2 layout with 1 sprinkler and 1 light, hemp is most efficient in a 2x3 layout with 2 sprinklers and 2 lights -2 heaters next to either of the layouts I mentioned is sufficient to heat the whole floor. I have 15 planters on each floor and they are all kept warm with 2 heaters. -Even with a pump, water can still only travel down after the first sprinkler. If you have 2 sprinklers on one floor and 2 sprinklers on another floor, always go directly from the pump/water valve to the uppermost or highest sprinklers and work your way down to ground level. Also worth noting you can only power 4 sprinklers on one pump. I don’t remember if this was mentioned or not, but just in case; your plants yield is based off of your lowest percentage management stat. Meaning if you have 75% land, but 100% everything else then your yield will STILL only be based off of *the 75% land stat* In essence, if you aren’t using fertilizer, your land stat will never be over 75-78%, so don’t worry about keeping water or warmth higher than that anyways.
Hey man - having some issues. Regardless of how many plots I have, they always get 0 water when the sprinklers are running. To test a theory, I even turned on 4 sprinklers for one crop plot…still zero. Then I rebuilt the whole base, and tried again (thinking it could’ve been a bug). But nope, same issue. Just can’t get a single damn plot irrigated.
It doesn’t work for me and I don’t know how to fix it like I have the catchers set up to barrel barrel output to a fluid pump switch input after that a fluid pump output to a splitter and those go to sprinklers but I just doesn’t work
You have water catchers? Are they on-top of the base? You might not even need the fluid pump you could probably just connect it straight to the sprinklers
I'm having an issue with the water catchers 😅 i placed 6 on top of my farmbase connected like your video said running down into my sprinkler, however the sprinkler will spray water for 1 second and then 5-10 seconds there's no water coming out, i waited it out and let the small generators run on fuel for like 30 minutes but the crops water percentage kept being 0% and i waisted 200 low grade 😅😅 do i still need to purify it first or what should i do? (Light and temperature i got 100%)
You'll need more water. Maybe a couple more water catchers. And definitely consider connecting all the water catchers to a water storage. Water catchers won't need to be purified the reason it's staying at 0 water is because the crops are consuming the water and there isn't enough to cover each of their needed water intake
@@notgr4ve I’m literally so confused on the action of swapping genes out. I have a near perfect plant one red, how to turn that into green without removing the green genes I already have. Doesn’t make sense
you didn’t explain how many branches your using ? what’s it connected to , like what about people who are new to rust ? why does majority of youtubers make videos assuming the audience knows all of the information beforehand rust videos are the worst i swear it’s always something being left out that fucks you over
It can be anything. It literally just needs power it doesn't matter how you do it. In the video I used a splitter that was powered by the branch out of an electrical branch. The splitters then went into the pumps and Water purifier. Later in the video when I was making the sprinkler system I only used a single branch
Most important part is crossbreeding, which you barely covered and what you explained is wrong (you don't simply place your clone in the middle and hope for the best). "BEST Farming Guide" which tells to look up crossbreeding on your own ...please delete this channel lol.
I'm sorry you think that. I understand though. I even suggested that the viewer should look it up and learn more about it. I wish I could have elaborated Alot more than just saying like 2 things. But anyway I didn't have enough time to actually try and learn it. I had to finish the video and upload it when the update came out. My phone was bugging the whole time when making it so I wanted to try and keep it as short as possible. And me using the * BEST * makes the video stand out more and I think I'm one of the only ones who made a farming guide specifically for Console Rust.
Thanks for watching. Make sure to check out my Mixing table and Tea Guide! Remember to use Timestamps!
get a mic please
I like the music more!
Side notes:
-Don’t plant seeds until your planter is at least 3000ml full of water.
-1 Sprinkler is enough for 5 boxes max. If you have 4 planters you don’t need 2 sprinklers. But 1 light is only enough for 4 planters so if you have 5 planters on one sprinkler you’ll need 2 lights
-Because of differences in water consumption, berries are most efficient grown in a 2x2 layout with 1 sprinkler and 1 light, hemp is most efficient in a 2x3 layout with 2 sprinklers and 2 lights
-2 heaters next to either of the layouts I mentioned is sufficient to heat the whole floor. I have 15 planters on each floor and they are all kept warm with 2 heaters.
-Even with a pump, water can still only travel down after the first sprinkler. If you have 2 sprinklers on one floor and 2 sprinklers on another floor, always go directly from the pump/water valve to the uppermost or highest sprinklers and work your way down to ground level. Also worth noting you can only power 4 sprinklers on one pump.
I don’t remember if this was mentioned or not, but just in case; your plants yield is based off of your lowest percentage management stat. Meaning if you have 75% land, but 100% everything else then your yield will STILL only be based off of *the 75% land stat* In essence, if you aren’t using fertilizer, your land stat will never be over 75-78%, so don’t worry about keeping water or warmth higher than that anyways.
Very helpful thank you!
Best video I’ve seen yet for a console tutorial! Great work
So straight forward I like
Highly appreciate it man ❤
Who knew a pvp game has stuff like this in it… 💀
*A farming game has pvp in it
lol
Plz show how you did your electricity seems like everyone does it differently. How can I put heaters and lights without using so much branches??
Use splitters. 3 outputs each.
Appreciate the vid very easy to follow. Have a nice little setup.. for now 😅
Am I the only one that hates the new grapichs
nice job dude
Appreciate it
Crazy you make these on your phone. how long did it take to make?
Thanks. It took about a week. Working on it for a couple hours every day.
@@notgr4ve woah. How big was the file size? My phone would not handle this lmao
@@Elite-nl1yn I think it was almost 10Gb it took an hour or two to download and upload
Very helpfull guide, thanks man
Hey man - having some issues. Regardless of how many plots I have, they always get 0 water when the sprinklers are running. To test a theory, I even turned on 4 sprinklers for one crop plot…still zero. Then I rebuilt the whole base, and tried again (thinking it could’ve been a bug). But nope, same issue. Just can’t get a single damn plot irrigated.
Where are you getting the water from?
Most likely the reason it isn't working is because the water is salty. You need the powered water purifier
@@notgr4ve Yup. Had my inputs and outputs for my purified water all messed up. Low IQ moment by myself lol.
@@likeaprotutorials5150 having the Same problem
Do you need heat in greenland
Nope. It's the best place to grow crops. Perfect temperature so you won't be needing heaters
Any one know what buttons to pres to crossbreed or do you just have to clone it? (Ive spent hours trying to figuer it out and still havent😂)
Clone it I think
Plants enter a Crossbreeding stage during Growth
Potato and Berries only spawn in Forest area, but yea still around the world
I need help knowing how tou connect all of the electircty i barley use it so idrk
I've made an electricity guide on my channel.
It doesn’t work for me and I don’t know how to fix it like I have the catchers set up to barrel barrel output to a fluid pump switch input after that a fluid pump output to a splitter and those go to sprinklers but I just doesn’t work
It says it’s getting water but it won’t go on
And yes the fluid pump switch has power
You have water catchers? Are they on-top of the base? You might not even need the fluid pump you could probably just connect it straight to the sprinklers
I'm having an issue with the water catchers 😅 i placed 6 on top of my farmbase connected like your video said running down into my sprinkler, however the sprinkler will spray water for 1 second and then 5-10 seconds there's no water coming out, i waited it out and let the small generators run on fuel for like 30 minutes but the crops water percentage kept being 0% and i waisted 200 low grade 😅😅 do i still need to purify it first or what should i do? (Light and temperature i got 100%)
You'll need more water. Maybe a couple more water catchers. And definitely consider connecting all the water catchers to a water storage. Water catchers won't need to be purified the reason it's staying at 0 water is because the crops are consuming the water and there isn't enough to cover each of their needed water intake
@@notgr4ve ok i will try that out ty 😁
It keeps on saying connection requires pump! What do I do someone help
Nice video... Would be great with a voice over instead 🤙
why don’t my crops grow, for example my berry plants don’t go berrys and they are all green clones 😭
They are all getting enough water, lighting ect?
Nice video, but turn the music down!
Man I’ve just finished genetics at school I don’t wanna do this shit in rust now😭😭
I came here for cross breeding and bro really said look up more about it.
Sorry dude I didn't have enough time 😭
@@notgr4ve I’m literally so confused on the action of swapping genes out. I have a near perfect plant one red, how to turn that into green without removing the green genes I already have. Doesn’t make sense
@@treyyoungley6171 watch jfarrs guide on it or use the website called “ Rust Breeder “ sounds weird but just look up Rust genetics calculator
@@notgr4vegrave you ain’t doing the best rn.
you didn’t explain how many branches your using ? what’s it connected to , like what about people who are new to rust ? why does majority of youtubers make videos assuming the audience knows all of the information beforehand rust videos are the worst i swear it’s always something being left out that fucks you over
It can be anything. It literally just needs power it doesn't matter how you do it. In the video I used a splitter that was powered by the branch out of an electrical branch. The splitters then went into the pumps and Water purifier. Later in the video when I was making the sprinkler system I only used a single branch
Were you expecting an electrical tutorial too or what???
If you’d talk bro your videos would be better and get the views your wanting 😊
When I get my PC. It's too difficult on a phone 👍
every server is full and the game crashes the games broken again
not surprised
@@itzinfinite519ik
What a shit update.
Shi so much work like heater and shi com on I can plate then irl easier with out that
Most important part is crossbreeding, which you barely covered and what you explained is wrong (you don't simply place your clone in the middle and hope for the best). "BEST Farming Guide" which tells to look up crossbreeding on your own ...please delete this channel lol.
I'm sorry you think that. I understand though. I even suggested that the viewer should look it up and learn more about it. I wish I could have elaborated Alot more than just saying like 2 things. But anyway I didn't have enough time to actually try and learn it. I had to finish the video and upload it when the update came out. My phone was bugging the whole time when making it so I wanted to try and keep it as short as possible. And me using the * BEST * makes the video stand out more and I think I'm one of the only ones who made a farming guide specifically for Console Rust.
A love spreading guy. One of those collecting naked skulls😂
8oooomoooo8 why you mad bruh.
Get a mic expect people to watch this
fr
bro can't read🤯🤯🤯🤯🤯
*300 people have disagreed with you*
I did
Youse da goat