Sunbeam Tiger - Restoration - Replacing the Sills - part 5 - panel fitting

Working on my Sunbeam Tiger
Restoring the sills inside and out. I purchased replacement panels from the UK and this is the process of cutting them down, shaping, finishing the sill rear seam, fitting the fender patches, and what I needed to do on my project.
I have been building up to this restoration for years and this sill replacement is the biggest task. Cutting up the original and cutting the patch panels was a bit nerve racking.... but I finally tackled it and its fine and I hope I can help others see that it is not so bad.
My Tiger is going to be awesome if I can ever get it done... doing these videos helps me make "do-able" chunks and stay motivated. So if you like what I am doing please subscribe to support my effort.
Thanks for watching

[@MarkHankewycz]

Hi Wayne, Watch your entire series. Great stuff. I have a similar tiger project where I need to do the under structure, pan and sills. Any help you can provide on the jig you built for the bracing. I'm essentially looking for the measurement from the window frame hole to the rear door location you mentioned. My structure is sagging slightly - so trying to get good reference points to test out on my project. Thanks in advance. Mark

[@r.bearmonteiro5170]

were do you get your replacment panels