Made A Vice out of Scrap

Just needed a small vice for drilling/milling mainly for small parts and I tried to made it out of aluminium scrap, it's very handy to have one and I'm glad I build one :).

[@ChrisHarmon1]

Excellent work! Very underrated channel.

[@ParsMaker]

Thank you 😊

[@mftmachining]

Nice work, unusual design with some smart solutions. I like it.

[@ParsMaker]

thanks for watching

[@TalRohan]

very attractive little vice but I noticed two problems when you used it.
One is that its too small to hold safely and needs something to anchor it to the ways on your drill table and the other is you have a lot of slack in your drill table, hence the vibration seen on camera.
Cracking work and thankyou for sharing

[@ParsMaker]

actually just made this for holding small parts so I can hold on to it, about drill table you are right, is not tighten enough 😇, thanks for feedback

[@HS-hz4fx]

I like the milling pattern on the vice, nice work

[@ParsMaker]

thanks