It's based on a 2021 version of Netedit so I'm not sure if it's still available in the latest release... If so, it should be under "network" tab -> "create edge" button -> then the "two-way" checkbox.
As far as I know, this will requires some coding interface through Traci ( sumo.dlr.de/docs/TraCI/Interfacing_TraCI_from_Python.html). Their GUI might not have supported this feature yet.
i have repet every step with care..but at the end sumo config file stops at 0.00 and said all vehicle have left the simulation..kindly guide me how to rectify this issue..any one here is more than welcome to help and comment
I suppose that means the simulation has finished. If your have set up the output path as in 14:20, you should be able to see the results after the note.
I found out the problem, you skipped a step he did, you need to open Sumo GUI in the Netedit, then after opening the SumoGui you need to save it as config, then it should run smoothly. Encountered the problem until I realized I missed this step.
thank you very much
good tutorial thank you very much
Thank you so much!
Fantastic! Thank you;-)
讲得真好，大佬要是有空可以考虑录个中文的放B站上供国内朋友学习学习
怕是没空了😂feel free to搬运和二次加工哈
网课大佬！
可怕！
i can't find the file results ?
Where can I get the two way mode tick button?
It's based on a 2021 version of Netedit so I'm not sure if it's still available in the latest release... If so, it should be under "network" tab -> "create edge" button -> then the "two-way" checkbox.
Can someone tell me how do I add variable speed signs to the simulation?
As far as I know, this will requires some coding interface through Traci ( sumo.dlr.de/docs/TraCI/Interfacing_TraCI_from_Python.html). Their GUI might not have supported this feature yet.
i have repet every step with care..but at the end sumo config file stops at 0.00 and said all vehicle have left the simulation..kindly guide me how to rectify this issue..any one here is more than welcome to help and comment
I suppose that means the simulation has finished. If your have set up the output path as in 14:20, you should be able to see the results after the note.
I found out the problem, you skipped a step he did, you need to open Sumo GUI in the Netedit, then after opening the SumoGui you need to save it as config, then it should run smoothly. Encountered the problem until I realized I missed this step.
毕竟科学家
阿西吧 嘲讽开满了～
i wish you would have put the code down, cause it's hard to rewrite everything, while watching the video
In fact the codes are mostly automatically generated by the Netedit when you save the .XML files in this part 9:35
its to fast.. difficult to follow
too fast..