Homemade PCB's : Trial and Error

Am just expressing my point of view on Making Pcb's at home , it isn't that easy as others suggest using the toner transfer method.we learn a lot by trial and error.
SOCIALS:
WebSite ► www.tunmaker.tn/
Twitter ► / tun_maker
Facebook ► / tunisanmaker
Instagram ► / tunmaker

[@SuperDutchman59]

try to heat between two iron plates, squeezed in an induction oven, and print on aluminum foil, do not remove it, and etch after heating in the pickling bath

[@MrMaxyMahdia]

a frer mnin ta5ou fel materiels ?

[@TunMaker]

Nahj athina centre ville tunis

[@DeeegerD]

Lose the masking tape - not needed - the toner will stick in place with the heat and the tape is just insulating the heat from the paper under it.

[@rel375]

My God !!! this is very risky my friend. You may cut your hand with this paper cutter. There’s a cutter with an edge specially designed to cut PCBs and plastic boards. It's safe to handle, gives very clean and sharp cut and also goes much faster than this one you are using.

[@TunMaker]

Yes your right my freind ,thats careless old me. Next time that wont be the case :)

[@jeancloue5296]

pur le papier utiliser le papier emballage de noël ça fonctionne bien avec un fer a repasser