stark varg inside the motor unit

Поділитися
Вставка
  • Опубліковано 17 гру 2024

КОМЕНТАРІ • 20

  • @sethml
    @sethml 5 місяців тому +7

    Thanks! I'd love to see more of the motor controller, including some close-ups of the PCBs to see what the components are, and taking off the bottom cover to see how the FETs or IGBTs are cooled.

  • @tonik4379
    @tonik4379 4 місяці тому +4

    im interested to see the insides of the motor itself,good video

  • @raydonpubgm5233
    @raydonpubgm5233 4 місяці тому +5

    Teardown the motor

  • @timt1346
    @timt1346 27 днів тому

    I wish they had made bevel caps for the screw holes in the top of that black cover. That's just asking for water and dirt/mud to find its way in there and then turn into concrete.

  • @chubn1
    @chubn1 Місяць тому

    I am interested to see the screws and other components separated by yarn with 3 cheeseburgers unwrapped and a glove nearby for safety when it gets rainy out

  • @weekendveterans
    @weekendveterans 4 місяці тому +1

    Looks like the upgrade to the gen2 inverter with the charging port may not be too difficult.

    • @crherniman
      @crherniman Місяць тому

      Do you happen to know the difference between gen1 and gen2?

    • @weekendveterans
      @weekendveterans Місяць тому

      @ yep, charge port if fixed to inverter rather than wired to inverter and mounted back a touch. All it means is 1 less connecton in each wire. This has equated to less failures…both are good, gen 1 motors fail for different reasons, gen 1 and 2 are fine with latest software

  • @crherniman
    @crherniman Місяць тому

    Is the crankcase vent intended to be plugged with the small rubber tube with a bolt? The replacement I got has that same plug, but the bike itself has the vent tube that goes up and around the rear subframe.

  • @malyan77
    @malyan77 Місяць тому +1

    Hi, is it asynchronous motor, or with magnets?

  • @veldhuisracing
    @veldhuisracing 2 місяці тому

    Did you also disassemble the battery pack?

  • @RIPPERTON
    @RIPPERTON Місяць тому

    All the M6(?) bolts for the power bus bars phase and DC didnt look like they were torqued up properly.
    Too easy to loosen.

  • @raydonpubgm5233
    @raydonpubgm5233 4 місяці тому

  • @doronlola1763
    @doronlola1763 Місяць тому

    What power mosfets module did they use?

    • @RIPPERTON
      @RIPPERTON Місяць тому

      IGBT 420v

    • @doronlola1763
      @doronlola1763 Місяць тому

      @ thanks, do you know the product number?

  • @paulkerr2009
    @paulkerr2009 5 місяців тому

    👏👏👏👏👏👏

  • @fredwerx
    @fredwerx  5 місяців тому +2

    Go follow instagram.com/fredwerx

  • @EuropeanDreamz
    @EuropeanDreamz Місяць тому

    Email ?