Розмір відео: 1280 X 720853 X 480640 X 360
Показувати елементи керування програвачем
Автоматичне відтворення
Автоповтор
It's an easy job if you know how! I didn't know how properly but now I do 😂👍 thanks buddy 💯👌
Is that the way to tigten the axle I have never done it like that aways on the nut end not the shaft end
the rear axle nuts. are they both 85NM? or is the one on the caliper side a lower torque?
The big screw in the wheel wont moven even if i’d stand on it, what do i do?
Have you got a breaker bar? Because they’d do the job. It’s probs just on there really tight
Try put som wd 40 on it:)
mitä jäbä teki koska meikäl sama ongelm
Couldn't do this, the chain adjusters are seized on
Looked way to tight… Did u have to loosen it?
Yeah I made sure I loosened it straight after don’t worry :)
What size is the main bolt?
19mm
It's too tight...should have 36 mm slack
I tested mine. It's usually 35mm, sometime goes near 30 or 40mm. The service manual says 30-40mm is for my version, which is ok cause you adjust for 30mm in the tightest place. On the video it looks more like 20mm. It's probably too tight.
89 Nm.
![Motorrad Kettensatz-Wechsel | YZF R125 [HD]](http://i.ytimg.com/vi/WosyocZR61c/mqdefault.jpg)
It's an easy job if you know how! I didn't know how properly but now I do 😂👍 thanks buddy 💯👌
Is that the way to tigten the axle I have never done it like that aways on the nut end not the shaft end
the rear axle nuts. are they both 85NM? or is the one on the caliper side a lower torque?
The big screw in the wheel wont moven even if i’d stand on it, what do i do?
Have you got a breaker bar? Because they’d do the job. It’s probs just on there really tight
Try put som wd 40 on it:)
mitä jäbä teki koska meikäl sama ongelm
Couldn't do this, the chain adjusters are seized on
Looked way to tight… Did u have to loosen it?
Yeah I made sure I loosened it straight after don’t worry :)
What size is the main bolt?
19mm
It's too tight...should have 36 mm slack
I tested mine. It's usually 35mm, sometime goes near 30 or 40mm. The service manual says 30-40mm is for my version, which is ok cause you adjust for 30mm in the tightest place. On the video it looks more like 20mm. It's probably too tight.
89 Nm.