Find Taper Angle | Diameter using Taper Ratio | & Stock Over length

Поділитися
Вставка
  • Опубліковано 9 жов 2024
  • In this video I have taught how to calculate Taper Angle, Diameter using Taper Ratio and Stock Over length.

КОМЕНТАРІ • 12

  • @NishaLilhare-i3m
    @NishaLilhare-i3m 9 місяців тому +1

    min.dia.of shaft=83mm
    and amount of set over= 8mm

  • @rahultodkar9641
    @rahultodkar9641 Рік тому +1

    Nice information sir ji

    • @mechshiksha
      @mechshiksha  Рік тому

      Thank you so much sir🙏🏻🙏🏻

    • @gaming_minecraft111
      @gaming_minecraft111 Рік тому +1

      Yes sir, you are the best teacher 🙌🏻

    • @mechshiksha
      @mechshiksha  Рік тому

      @@gaming_minecraft111 thank you so much for your support ❤️

  • @NishaLilhare-i3m
    @NishaLilhare-i3m 9 місяців тому

    🙏

  • @NishaLilhare-i3m
    @NishaLilhare-i3m 9 місяців тому

    d=83mm and x= 8mm

  • @TyroneBeveridge-v2q
    @TyroneBeveridge-v2q Рік тому

    Nice but really the focus is out

    • @mechshiksha
      @mechshiksha  Рік тому

      Thank you so much for your feedback, can I please know what you mean by "focus is out"? Is the video blurry or something else?

    • @TyroneBeveridge-v2q
      @TyroneBeveridge-v2q Рік тому

      @@mechshiksha yes sir it was blur couldn't see to well but understand thank you

    • @mechshiksha
      @mechshiksha  Рік тому

      @@TyroneBeveridge-v2q Oh ok sir, I will take care of this in my upcoming video, thank you for feedback ☺️