Thank you guys for this video. I have my yokomo on its way and believe or not I haven't seen many videos by guys who are experienced. I appreciate the knowledge and the entertainment. Cheers.
I both love and hate these videos. I love watching them. Hate that I always want one of these. Lucky its a buggy and not a short course or stadium truck.
Great video guys. Do you happen to have the part number for the aftermarket Yokomo shims that you added? There seems to be a few of similar size available, so I just want to make sure I get the correct ones. Edit: I think I’ve found them Zc-S320, but sadly can’t seem to get them in the UK. I did notice ZC-S30C but they are marked as 3mm diameter as opposed to 3.1, so just wondering if these at 3mm would work, or is that extra 0.1mm required?
Thank you! Which area are you shimming? The boys are using ZC-S40SA 4.0mm shims in the steering. If using shims for 3mm screws then any of the 3mm shims will be fine. The stainless ones are oddly described as 3.1mm which will be the actual hole diameter. That is the same for any 3mm shim to allow for clearance of the 3mm screw.
@@HearnsHobbiesMelbourne thank you so much. I was looking to shim under the bellcranks (although I’ve seen some people put them on top of the bellcranks)
Thank you guys for this video. I have my yokomo on its way and believe or not I haven't seen many videos by guys who are experienced. I appreciate the knowledge and the entertainment. Cheers.
Glad it was helpful!
I both love and hate these videos. I love watching them. Hate that I always want one of these. Lucky its a buggy and not a short course or stadium truck.
Ahah, good one! Glad you are enjoying them. Thanks.
Great videos guys, enjoying these type of videos from the states. Cheers to you all at Hearns.
Great to hear! Thank you for watching!
Did I hear that correct...The aluminum front upper camber link mount does not require the slim nuts?
Correct! Thanks for watching!
Great video guys. Do you happen to have the part number for the aftermarket Yokomo shims that you added? There seems to be a few of similar size available, so I just want to make sure I get the correct ones. Edit: I think I’ve found them Zc-S320, but sadly can’t seem to get them in the UK. I did notice ZC-S30C but they are marked as 3mm diameter as opposed to 3.1, so just wondering if these at 3mm would work, or is that extra 0.1mm required?
Thank you! Which area are you shimming? The boys are using ZC-S40SA 4.0mm shims in the steering. If using shims for 3mm screws then any of the 3mm shims will be fine. The stainless ones are oddly described as 3.1mm which will be the actual hole diameter. That is the same for any 3mm shim to allow for clearance of the 3mm screw.
@@HearnsHobbiesMelbourne thank you so much. I was looking to shim under the bellcranks (although I’ve seen some people put them on top of the bellcranks)
Glad to be of assistance!
Is there a chance I can get a list of important parts for the cal?
Does the cal3 crank case fit on the 3.1?
Yes, it does!
@Hearns Hobbies thanks. You will find a few of my comments I'm more than jazzed right now.
Good video guys, does seem a bit out of focus.
Yes, the next one should be good again! Sorry!