Fix YBR 125 clutch slipping

Brought some new steel plates for nothing lol ..ah well ..least it done now regardless
Symptoms ..
At around 40-50mph the Rev counter used to fly straight up into red like I'd suddenly pulled clutch in ...clutch was obviously slipping (max top speed was only 50mph) ..now it's all fine and can hit 70mph .....if I'd known I could sand the steel discs I could have saved some money and time having to fit 2 clutches lol .....

[@tizcoloko]

Have replaced new discs and suddendly the slipping and revs when reaching 6000 rpms, would try sand them, thanks for the advice from a friend in shith**l**e México. The discs are new and the clutch basket too.

[@oldfartuk]

yes , clean and sand them

[@danielevan2232]

So I'm have same issue thinking the stell is good after changing the clutch pads and slipping like a f***er hoping new stell plates solve my slipping issue

[@lyonscultivars]

Good video. My bike seems to now slip under good revs on 6 month old friction disks. Is there some form of adjuster to compensate for the different thicknesses or sonthing

[@oldfartuk]

sadly not as such ..just the normal cable adjuster should have around 3 mm of free play ...only thing you can do is change the friction discs and clean / replace the steels

[@gideonsikk8733]

Did u use ur old gasket cover

[@oldfartuk]

yes .. if you very careful in removing it so not to rip it ..its fine to reuse

[@driftr1dr719]

What was the mileage on the YBR sir?

[@oldfartuk]

47k..it's quite a lot and I'm sure it's the original one (2005)

[@greyriddance64]

@@oldfartuk 45k on my '07 YBR. Still going strong but sometimes the clutch slips a little, but only when pinning it and shifting above 6k rpm.
Gonna check plates since I will be cleaning the oil filter soon, hence opening the right hand side of the engine.