I have an idea for this what if you guys seal the shaft inside the housing and add magnets to the output. This will make it so that you will not have to use seals in the housing "unless you want to throw out the bearings and use a pressurised oil system going through a journal bearing, it will last longer and you can directly connect a gear pump to feed the system for continues use in I say a household setting for emergency power?"
I have an idea for this what if you guys seal the shaft inside the housing and add magnets to the output. This will make it so that you will not have to use seals in the housing "unless you want to throw out the bearings and use a pressurised oil system going through a journal bearing, it will last longer and you can directly connect a gear pump to feed the system for continues use in I say a household setting for emergency power?"
What software did you use for proofing and understanding stresses?
Abaqus FEA
The most important question is how much power in watts do I get out of it at e.g. 5 bar steam pressure ?
1.5kW @ 4 bar steam pressure
Please watching New Rotary engine (fail) from Indonesia...