Diamond D3000n Discone Antenna

Поділитися
Вставка
  • Опубліковано 22 жов 2024

КОМЕНТАРІ • 53

  • @chrisg7160
    @chrisg7160 Рік тому +1

    I just bought this antenna and plan to use it for scanning. I found your video to be very helpful. Thank you for making it.

    • @du7jay
      @du7jay  Рік тому +1

      Tnx goodluck. 73 😊👍🏻

    • @ОсиповКирилл-щ9ч
      @ОсиповКирилл-щ9ч Рік тому +1

      What cable do you plan to use to connect to the receiver?

    • @chrisg7160
      @chrisg7160 Рік тому +1

      @@ОсиповКирилл-щ9ч I’m using LMR 400 with type N connectors (45’ length)

  • @t0nito
    @t0nito Рік тому +2

    I just bought this for my RTL-SDR, it's a very cool antenna, the only downside I see is that you have to remove some radials to access the screws to then access the connector. I have this on a temporary rig and when I'm putting it on the roof I have to dissassemble half of the antenna to reach the connector :P

  • @Shipfixer
    @Shipfixer 3 роки тому +1

    Very well explained. Instant LIKE! I'm going over to amazon and get one right now! Thanks. Greetings from Alaska.

    • @du7jay
      @du7jay  3 роки тому +1

      73 from Cebu Philippines de du7jay :-)

    • @ericdreizen1463
      @ericdreizen1463 3 роки тому +1

      I got mine from Gigaparts. For my new IC R8600. Should work well! All I have to do now is get the thing up in the air!

  • @ericdreizen1463
    @ericdreizen1463 3 роки тому +1

    I just bought an IC R8600 & was wondering how to connect this antenna to the VHF section. U just cleared that up. Thanks.

    • @du7jay
      @du7jay  3 роки тому +1

      ...good luck and enjoy Ham radio :-) 73

    • @ericdreizen1463
      @ericdreizen1463 3 роки тому +1

      @@du7jay This is for SWLing in my room. My shack's out back. TY!

  • @cnick6
    @cnick6 3 роки тому +7

    You should really use LMR400 with a proper NMO connector at the antenna connection. Also anti-seize is recommended on the mounting hardware. Dialectric grease is best on the radials and loctite down the nuts/hex screws where appropriate.

    • @du7jay
      @du7jay  3 роки тому +1

      yes I agree... I did those on the final install,. 73 de du7jay :-)

    • @MrWarface1
      @MrWarface1 2 роки тому +2

      I bet you are the type of guy to use a torque wrench on an oil
      change.

    • @bullhead520
      @bullhead520 2 роки тому

      Thank you for your prompt response and assistance 👍

  • @anonymous_friend
    @anonymous_friend 11 місяців тому +1

    How is the antenna holding up? Would you purchase it again? I'm trying to figure out which one to get. Thanks😊

    • @du7jay
      @du7jay  11 місяців тому

      Yes its still up on my mast👍🏻

  • @dang25272549
    @dang25272549 3 роки тому +1

    Thanks so much for helping me make up my mind real quick 😁👍.

    • @du7jay
      @du7jay  3 роки тому +1

      good luck and 73 ;-)

    • @du7jay
      @du7jay  3 роки тому

      @@daveaf3023 😅

  • @richardpattison5525
    @richardpattison5525 3 роки тому +2

    Great video. Thanks for the info

    • @du7jay
      @du7jay  3 роки тому

      Tnx 73 du7jay 😊

  • @bluediamondsquaresroad5871
    @bluediamondsquaresroad5871 Рік тому

    How did you connect the pole that has the u-bolts around it to the tripod? Is the pole screwed into the tripod mount screw? (5/8 or 3/4) What kind of tripod is used for the base?:)

  • @marymartinez195
    @marymartinez195 3 місяці тому

    Wonderful Antenna👍👍

    • @du7jay
      @du7jay  3 місяці тому

      Thank you! Cheers!

  • @bullhead520
    @bullhead520 2 роки тому +1

    What size or type of coax do you recommend for scanner reception? Thank you, James

    • @du7jay
      @du7jay  2 роки тому +1

      ..a good quality rg58 or rg8 type coax will do just fine.

  • @anthonygallo3576
    @anthonygallo3576 3 роки тому +1

    Good video on antenna, I would love to know what is the minimum size diameter mast you can use .it did not look.like.you.could tighten those u bolts
    Any smaller?

    • @du7jay
      @du7jay  3 роки тому

      @anthony gallo tnx ,.. as per the instruction sheet, applicable mast diameter is from 25-52mm 😊👍🏻

    • @elexismaripaloma3034
      @elexismaripaloma3034 3 роки тому +1

      @@du7jay where did u get or purchase the discone>? how much was it/?

    • @du7jay
      @du7jay  3 роки тому

      @@elexismaripaloma3034 hello sir, this antenna is available at #alphaSource mobile# +639229684026 for around 3-4k peso

    • @elexismaripaloma3034
      @elexismaripaloma3034 3 роки тому +1

      @@du7jay i see. noted and tnx.

    • @cnick6
      @cnick6 3 роки тому +1

      1 inch to 2 inch mast OD

  • @teunaydin
    @teunaydin 3 роки тому +1

    Excellent show thanks

    • @du7jay
      @du7jay  3 роки тому

      Thanks ..73 de du7jay 😊✌🏻

  • @cnick6
    @cnick6 3 роки тому +1

    Hmm did you calibrate your NanoVNA? My D3000N is under 2.0 SWR from approximately 140 Mhz to 1 Ghz.

    • @du7jay
      @du7jay  3 роки тому

      ..yes my nano vna was calibrated :-)

  • @rsnk1313
    @rsnk1313 2 роки тому +1

    Does the U bolt included in the packaging?

    • @du7jay
      @du7jay  2 роки тому

      Yes sir its included 👍🏻😊

  • @Bonifaceus
    @Bonifaceus Рік тому +1

    what is the difference between a Slav and an american. we do not use instructions for assembly. and everything works... :)

    • @du7jay
      @du7jay  Рік тому +1

      hams dont need manual 😂😂😂

    • @Bonifaceus
      @Bonifaceus Рік тому +1

      100% agree. I am preparing to become a radio amateur, so I watch educational videos. Greetings from Ukraine...

    • @du7jay
      @du7jay  Рік тому +1

      @@Bonifaceus stay safe always. 73 from Cebu Island

    • @Bonifaceus
      @Bonifaceus Рік тому

      @@du7jay
      thank you. and you are 73 from Krivoy Rog...

  • @naveairone
    @naveairone Рік тому

    Is good for to Recive hf too?

  • @ireadursoul
    @ireadursoul Рік тому

    hpw is the reception in the bands?

    • @du7jay
      @du7jay  Рік тому

      reception is very good 👍

  • @yuriykot10
    @yuriykot10 2 роки тому +1

    D130=D3000n

  • @bryandulanas6325
    @bryandulanas6325 3 місяці тому

    Saan po makabili nitong antenna bossing?

    • @du7jay
      @du7jay  3 місяці тому

      @@bryandulanas6325 message tomorrow sir Bryan. 73

  • @VA3AGV
    @VA3AGV 3 роки тому +1

    Rolex date adjust.

  • @eknaap8800
    @eknaap8800 3 роки тому +1

    Using an adjustable spanner and a PL 259 connector here is very cringeworthy to me... 😟