Hi, If you keep them aligned, then bolts are aligned with treaded tappings, and there no need to get trouble, or else you need to keep on rotating until it aligned. Even if you fit them in misaligned condition, there will be no problem, but it will consume more time to rotate both parts until aligned. There are so many brands that are available in the market . SKF, FAG and some are local depends on different countries. You can check in your local industrial traders or Alibaba.com
@@superindustrialguide2765 so it doesn't matter if this two part have the two open line allignated and follow each other or if they don't follow each other, because this system is power type and it doesn't matter the orientation of this two part as long as all screw are thigh ? ( it's because one technician told me it should be not allignated but i'm sure that those open line were following it other when i dismentled this taper lock and assembled again) best regards Yann.
Very good sir ji badiya bata rahe hai jari rakhiye
Thanks . Ji jaroor jari rahenga bas aap logo Ka Aise hi response Milta rahe
बहुत सुन्दर प्रस्तुति सर
Thanks brother . Please help me to make 1000 subscribers which will motivate me to make more videos like this.
Very good
Saudações do Brazil.
Thank you
Your most welcome
👍
Hello, does the two line of the taper lock should be allignated or not ? And why they shouldn't ?
Do you know the brand of this taper lock ?
Hi,
If you keep them aligned, then bolts are aligned with treaded tappings, and there no need to get trouble, or else you need to keep on rotating until it aligned.
Even if you fit them in misaligned condition, there will be no problem, but it will consume more time to rotate both parts until aligned.
There are so many brands that are available in the market . SKF, FAG and some are local depends on different countries. You can check in your local industrial traders or Alibaba.com
@@superindustrialguide2765 so it doesn't matter if this two part have the two open line allignated and follow each other or if they don't follow each other, because this system is power type and it doesn't matter the orientation of this two part as long as all screw are thigh ?
( it's because one technician told me it should be not allignated but i'm sure that those open line were following it other when i dismentled this taper lock and assembled again)
best regards
Yann.
Yes.
Where can I find taper lock , I need for 50 mm shaft
In which country are you staying?
Check in alibaba.com
You can also check in your local area industrial traders where you can find.