This is exactly what I need to create for my kitchen. I don't have extra cabinet space to place pull out trash cans in an existing cabinet so I'll to do a free standing cabinet like this one. My shop and woodworking skills are quite a bit below yours though. Do you have advice or recommendations for slightly simpler version of this? Thanks for sharing your work.
If your looking to do an easy version i know they sell pull out kits that have the slides brackets and cans on amazon. Rev-A-Shelf 53WC-1835SCDM-217 Double 35- Quart. All you would have to build is your cabinet box and door the kit would cover the rest. Let me know if that helps.
Nice job. Your video filled a couple of voids in my planning.
I really like this build. About how much did you add to the width of the cabinet in comparison to the width of the trash cans?
The face frame opening is 15 3/8. The garbage can top is 14 3/4. Leaves you with 5/8 ÷2 gives you 5/16 on bothsides. Hope this helps you .
I really would like to see the island attached to it
If you watch my last video it will show the kitchen done the pull out garbage can is at the end of the island.
ua-cam.com/video/NA5MuWhC6Vs/v-deo.html
This is exactly what I need to create for my kitchen. I don't have extra cabinet space to place pull out trash cans in an existing cabinet so I'll to do a free standing cabinet like this one. My shop and woodworking skills are quite a bit below yours though. Do you have advice or recommendations for slightly simpler version of this? Thanks for sharing your work.
If your looking to do an easy version i know they sell pull out kits that have the slides brackets and cans on amazon. Rev-A-Shelf 53WC-1835SCDM-217 Double 35- Quart.
All you would have to build is your cabinet box and door the kit would cover the rest. Let me know if that helps.
What pocket drill jig would you suggest. .?
I use the kreg K5 master would definitely recommend.
why did you use pocket screws vs tenon and mortise joints?
I use pocket screws when working with plywood. Normally use mortise and tenon joint with soild woods.
what kind of wood is that
The plywood is 3/4 maple veneer. The hardwood is also maple planed down to 1/2 inch.
Where did you find the cans? Looking for a set like these.
They are from rev a shelf . I ordered them from amazon
Nice I like it ... about how tall was the drawer box 6" to 8" ?
The outside of the box is 8in. Inside the box is 6in.
Do you have a link for the hardware (soft-close rails)?
I do not have a link for the ones I ordered they were off Amazon blum 563H and then the length you want. Hope this helps.
Step by step is stating sizes and cuts!!!
what's the size of the garbage can?
The cabinet is 18in wide 34.5 tall. 21in deep. The garbage can is from Rev-A-Shelf LxWxH 10.75 x 14.75 x 21.75 inches.