Це відео не доступне.
Перепрошуємо.
2005 Ford F150 front differential removal, install & SURPRISE
Вставка
- Опубліковано 7 сер 2024
- In this video I'm gonna show you why and how I had to replace front differential on my 2005 Ford F150.
My old one failed. Got stuck in 4H. The truck was making a funny grinding noise on 2H starting around 50 km/h and when I switched to 4H it immediately stopped. So I drove it for a while in 4H and then it happened. Loud noise at 80kmh like a steel against the steel, got the truck to a hard shoulder quick and just in time, then it stopped completely with wheels blocked. Switching into 2H made the truck unstuck and got home like that.
I'm not sure what was the main cause of it but I surely found a result of it. Watch the whole video or click on timeline below to switch between video chapters.
There's also a little hint what to do with that thick Motorcraft 80W90 oil to make it flow better even using cheap fluid pumps.
⏱timeline⏱
--------------
0:00 - Intro
3:46 - CV axle disconnect
4:53 - front driveshaft disconnect
5:23 - front diff vent hose disconnect
5:39 - steering column disconnect
6:08 - steering rack lowering
7:27 - cross member bracket removal
7:49 - IWE note
8:08 - front diff 1st bolt
9:40 - front diff 2nd bolt
10:16 - front diff 3rd bolt
10:47 - newer diff preparation
13:20 - steering rack install
13:39 - steering column, vent hose install
13:56 - gear oil preparation
17:20 - front diff gear oil fill up
20:49 - final note (almost final)
21:11 - old diff disaster
------------------------
Tools I needed:
----------------
ramps
bricks
jack
lumber support
penetrating oil
wire brush
marker
plastic bag
trim removal tool
rtv silicon
fluid pump
2 liters Motorcraft 80W90
a steel can
portable heater
M12 triple square
13mm 3/8" socket
15mm 3/8" socket
15mm 1/2" socket
18mm 1/2" socket
3/8" ratchet
3/8" 6" extension
3/8" 10" extension
1/2" ratchet
1/2" braker bar
1/2" 6" extension
adapter 1/2" to 3/8"
15mm hex wrench
18mm hex wrench
21mm hex wrench
24mm hex wrench or 24mm 1/2" deep socket
1/2" torque wrench (up to 111ft/lbs)
3/8" torque wrench
This video is about why, what, when and how I did something. It is not a guide nor training, I'm not a professional. If you follow any of it, I take no responsibility.
A grind in the Alberta winter 🥶