2005 international 9400i eagle bunk Blower fan Repair

On this video you can find locations for their front blower motor in bunk blower motor on the international 9400 Eagle you can also find components like heater core AC evaporator in blender words for your heater I hope you find a spirit with your helpful

[@jonathanking6546]

Thank you for the video. It saved me a lot of research. Really appreciate it.

[@noelhine3794]

Good info but the beeping takes over the whole video

[@Trucker_Bud]

Thank you my good sir

[@joeh8175]

I have a 1999 would the steps be the same?

[@daveellis5100]

Recorded vertically:/

[@h22eh6]

Awesome video thank u so much. I’m in ny with no heat. I have a 2006 9400i with cm870. I need to replace both blower motors or at least I need to check power. Would u happen to have part numbers for both blower motors?

[@brianperez9170]

Did you ever fix your fan issue ?

[@h22eh6]

BRIAN PEREZ both blower motors were toast

[@JoseluisPerezArreola]

@@h22eh6 are the front and rear blower motors the same part number?

[@h22eh6]

@@JoseluisPerezArreola it was awhile ago but I believe they were different

[@EDUBS2000]

How did you remove the seatbelt from the wall?? I'm lost... Thanks in advance

[@Omosula]

Bro where you located I will bring my truck

[@aztxtransport2776]

My dash blower stopped working for 1,2,3 speeds. Is only working for high speed #4. What could be wrong?

[@brianperez9170]

What year and make truck you working on ?

[@aztxtransport2776]

BRIAN PEREZ international 9400 i. 2005.

[@brianperez9170]

AZ Tx Transport it sounds to me that your dash motor blower resistor went out that is located under the passenger seat seat must be removed to get to it

[@aztxtransport2776]

BRIAN PEREZ
Dang, how that stressor looks like? Btw my bunk blower stopped working too. I just replaced it by myself 2 years ago. Is there stressor for it or something? Or shall i just go and replace the blower again?? Novice here not familiar with electric stuff.

[@royandrade2929]

I just replaced blower motor & resistor for dash. 1,2,3 work but resistor will smoke. 4 speed works for 20sec then kicks the fuse F1-A

[@mikeb.6502]

Damn bro, if you're going to be recording a how to video, next time make it to where people can understand your words. And how letting the air build up BEFORE you start a video so the low air warning isn't blasting the entire time you're mumbling.

[@TruckDriver326]

I understand him 😅