How to Install Carrier Reefer and Thermo King Drive Belts (The Special Technique)
Вставка
- Опубліковано 16 жов 2024
- This video is a step by step procedures of how to properly remove and install Carrier Reefer Drive Belts. You could also use this video to do Thermo King Reefer drive belts as well. Both Systems are the same. Looks can be deceiving, so don't underestimate these Reefer drives belts. They require special techniques to properly install and adjust them.
These Reefer drive belts are exposed to all weather mother nature throws at them, so they have a short life span. With good maintenance, they will last to its full potential.
I have seventeen years of experience on Carrier Reefer and Thermo King Reefer repairs, so you could count on my procedures to be extremely helpful.
Thank you for watching my channel. Please consider subscribing if you have not. It's free. It will help support this channel, and motivate me to show more videos.
Thank you for this video. I’m learning how to do it and this was a lot of good info. One thing is before putting the belts on check all the bearings to make sure they spin ok.
Wow, great information. Where did you get that tool?
You could get it online, but like I said in my video. You will need to practice using this tool, and if you get it right, it will come in handy.
This is very helpful. But what size is the Brice belt
Hello, how do i replace the water pump belt on the carrier reefer?
For the water pump drive belt removal, you will need to remove the pulley on the water pump .
@tholeetruck I removed the 4 bolts from the pulley but I can't get the pulley back on. Do I put the pulley then the belt? It's very tight
There are two procedures, depending on what model and type of the water pump pulley.
If the pulley is a split type, you will need to install the first half of the pulley in and then install the shims and rubber in. Finish off with the other half of the pulley. Make sure NOT to over tighten the four nuts.
For the one-piece pulley, you will need to install the new belt onto the crankshaft first, then install the water pump pulley in only 80% in at a tilt angle with ONLY one bolt hand twist in 10% into the thread. Slowly turning the water pump pulley clock wise until you can install another bolt on to the water pump thread. Countiniouse until you get all four bolt in. Finish of by tighten all bolt mounts down. Make sure NOT to over torque these four bolts. Don't worry about the belt sliding onto the pulley this way. It is the correct procedure.
@@tholeetruck Thank you very much. I really appreciate your help