Had the same issue with my rangey. Did a steering wheel calibration and sorted the issue. Your videos are always very simple and informative keep up the great work!
Well Luis , that was not too bad . In my experience U codes on a Range are expensive . I heard some joy in your voice while doing the test drive . I bought one for the Missus a few years back . Second hand of course . Good deal . That turned bad very fast and now I only like them when clients bring them in for repairs .
not a car i fancy unless brand new and manufacturers warranty running but an intersting video all the same,its great that you know how to use your scanner as often if you go in garages the first thing they want to do is clear all the codes
I do have same car.. For that break light when u change break bads u need to buy 2 new break sensors one for the front and one for the back.. very cheap here around 7$ each one
These nails have to be tracked and calibrated perfectly. If it pulls ever so slightly to one side and the steering wheel has to be slightly held to keep the car straight it can cause some wonderful fault codes (including air suspension faults). Usually happens on motorways (after 5 miles or so of straight driving) and not around town. Calibrating the angle sensor sometimes isn't enough. It's because the ABS sees the steering angle at a degree or two but the wheel speeds are all the same. It expects the left and right speeds to be slightly different. Tell tail is the air suspension warning on the dash.
You make it look so easy. Land Rovers seem to have a bad reputation for reliability, I have no idea if that’s deserved!! Any idea what would cause the steering calibration to be so wrong?
@@LMAutoRepairs my issue was different I had a blown fuse in location F15 behind glove box And that rectified my issue also to note when I check my steering it was within range, 580 to -580
First light Break fluid low will put light on I have the same problem with the other 2 lights . If I am driving and they come on I put car in neutral turn off ignition and restart and lights go off
I’m looking for the menu to turn the paddle shift mode on in a l320 07 2.7 d 6 speed I’ve fitted newer wheel and plug it in but won’t work I can’t find the menu I’ve tried few obd2 plug what cheaper option
Never done it on a Range Rover, don't know what that entitles either... if new wiring is required etc... But to code, most likely you will need SDD... 👍👍👍
Thanks for the video! My air compressor work only around 15-30 sec and it stop and the suspension light go on in the dash! My compressor is new. Anyone have a idea what it could be?
Tu devrais réparer ce petit problème qui,risque de devenir grand… j’habite sur l’île de Mayotte je préfère réparer ma range tous seul pour plus de garantie
Just saying, not trying to disrespect what you do. Break down whats the issue first then tell us how you came to the conclusion with the break down. Good vid tho.
Had the same issue with my rangey. Did a steering wheel calibration and sorted the issue. Your videos are always very simple and informative keep up the great work!
☺️
Thanks!
👍👍👍
Guys please I got the same problem, don't have the diagnostic to perform this can you guys help me. Got exactly the same problem
Without the tool there is not a lot any of us can help you with...😔
👍👍👍
@@LMAutoRepairs what's the best tool to use? Or maybe if you are in east Sussex you can come for my rescue.
Got Carly but it is useless.
Many are capable of doing it...
I am not near, but surely there is a garage around you with a tool that can...
👍👍👍
Well Luis , that was not too bad . In my experience U codes on a Range are expensive . I heard some joy in your voice while doing the test drive . I bought one for the Missus a few years back . Second hand of course . Good deal . That turned bad very fast and now I only like them when clients bring them in for repairs .
12
My experience makes me to agree with you...
😊
Nice one man. The rear door intermittent problem will be nice video to watch too. This is the real problems. 👍
Coming next...😋
👍👍👍
not a car i fancy unless brand new and manufacturers warranty running but an intersting video all the same,its great that you know how to use your scanner as often if you go in garages the first thing they want to do is clear all the codes
😊
👍👍👍
A specialist like you,are fantastic!
Hvl.
☺️
I am not a specialist...
I am just a DIY guy...
👍👍👍
Even Mr Awesome(simplydiagnostic) scares Land Rover!
You are brave man Luis.
Happy days to the owner.
😊
👍👍👍
Fantastic! What a help for me.I hope it will help fix this same fault in my car. Thank You and best wishes!
🤞
Good luck!
👍👍👍
I do have same car.. For that break light when u change break bads u need to buy 2 new break sensors one for the front and one for the back.. very cheap here around 7$ each one
If they have been triggered yes, they need replacing.
👍
Nice work, I really appreciate your efforts
😊
Thanks!
👍👍👍
Mulțumesc 🤗.. Foarte bun 🙏🫂
Great video mate. Thank you. Have the same issue. That will be it sorted now. 👍
😊
👍👍👍
Awesome Luis, I could hear your smile:)
😊
😅
You are a brave teacher thank you .
😊
👍👍👍
These nails have to be tracked and calibrated perfectly. If it pulls ever so slightly to one side and the steering wheel has to be slightly held to keep the car straight it can cause some wonderful fault codes (including air suspension faults). Usually happens on motorways (after 5 miles or so of straight driving) and not around town. Calibrating the angle sensor sometimes isn't enough. It's because the ABS sees the steering angle at a degree or two but the wheel speeds are all the same. It expects the left and right speeds to be slightly different. Tell tail is the air suspension warning on the dash.
👍👍👍
Nice work doutor luis
😊
Thanks!
👍👍👍
You make it look so easy. Land Rovers seem to have a bad reputation for reliability, I have no idea if that’s deserved!! Any idea what would cause the steering calibration to be so wrong?
🤷♂️
Who knows... I had no background on the car... therefore it is difficult to tell...
Thank you for watching!
If this resolves my issue I’ll grateful as the SAS module is over $400
🤞
👍👍👍
@@LMAutoRepairs my issue was different
I had a blown fuse in location F15 behind glove box
And that rectified my issue also to note when I check my steering it was within range, 580 to -580
@anthonymullings
Nice you found the issue!
@ indeed, it was starting to really irritate me
Super Video,super Erklärung. 👌👌 Very Nice your Video Help Me Very much. Thx 👌👌
😊
👍👍👍
HI , Man thanks for the video , i also got the light for the brake showing not in orange but in red , how can i fix it ?
Have you scanned the car?
👍👍👍
Strange to see a driving range rover lol,usually broke down on the side of the road 🤣 keep up the great content
🤣🤣🤣
👍👍👍👍
Thank you for another great video!!!
😊
Thank you for watching!
👍👍👍
Very helpful video
Thanks!
👍👍👍
First light Break fluid low will put light on I have the same problem with the other 2 lights . If I am driving and they come on I put car in neutral turn off ignition and restart and lights go off
Eres muy bueno en lo que haces, como siempre👏👏
😊
👍👍👍
Good job mate 👌
Thanks!
👍👍👍
Very good, thanks for the vid. Very useful. What's the software you're using?
Software?
What are you referring to?
👍👍👍
Very informative vedio ❤️❤️👍👍
Thank you!
👍👍👍
Great video. Very helpful for us as owners of these vehicles. 👌
😊
👍👍👍
Pirmanote U2023-86
Hello mate! Thanks for your video. Can you tell us which diagnose program do you use please?
In this video, was the MS908P...
Thank you for watching!
👍👍👍
@@LMAutoRepairs can I use Ancel from eBay it says it fit for Range Rover?
Ancel?
Never heard of that...
Sorry...
I’m looking for the menu to turn the paddle shift mode on in a l320 07 2.7 d 6 speed
I’ve fitted newer wheel and plug it in but won’t work I can’t find the menu I’ve tried few obd2 plug what cheaper option
Never done it on a Range Rover, don't know what that entitles either... if new wiring is required etc...
But to code, most likely you will need SDD...
👍👍👍
What's the cost of the scanner that ur using, I have the Autel MaxiDas.
I bought my one few years back... I am pretty sure the price has changed since...
👍👍👍
Thanks for the video! My air compressor work only around 15-30 sec and it stop and the suspension light go on in the dash!
My compressor is new.
Anyone have a idea what it could be?
Have you scanned the car?
@@LMAutoRepairs no I’m stock at home
But I will tow it to the garage no choice
Still, a scan it is probably the best next step... anything else will be pure guess work...
👍👍👍
My Range Rover went into limp mode how do I find out if it’s the transfer case module
Scan the car...
👍👍👍
Bro I need help! Got the same problem.
The fix is on the video...
👍👍👍
Just seen this and i have the same problem. Can you still drive with the lights on for a few days.?
As far as you don't go hill climbing...😋
👍👍👍
Ok thanks
Out of curiosity. What's the diagnostic machine your using and what would it cost to invest in one of these?
Autel MS908P...
I am not sure how much they go for at the moment...
👍👍👍
Hi what model aurel maxisys ?
MS908P
Thank you for watching!
👍👍👍
hi lui great vid can you recommend a good place for trader insurance cheers
Just search online, and get some quotations...
Let me tell you in advance, they are not cheap!...😓
Thank you for watching!
👍👍👍
Where abouts are you based? Very methodical
Uk... Cambridgeshire...
👍👍👍👍
thank you
Thanks!
👍👍👍
Thanks
👍👍👍
What kinda O.E.M reader is that....I need for all my fluids also
The scanner?
👍👍👍
@@LMAutoRepairs yes
@@LMAutoRepairs I'm about to order it if you tell me what kind it is boss
Autel MS908P
👍👍👍
You are a legend thanks for your time explaining to us quite clearly. 🫡
Cheers
Matt
😊
👍👍👍
Awesome
☺️
Thanks!
👍👍👍
Why do these lights keep coming on
Hello
Bonjour monsieu je le même problème onapa de garage kompeton et cherche ku faire vidange et placette de France alore je roule komsa
Tu devrais réparer ce petit problème qui,risque de devenir grand… j’habite sur l’île de Mayotte je préfère réparer ma range tous seul pour plus de garantie
2 mins in and i say take it to an auto electrician
16 minutes later and the problem was fixed...🤷♂️
ترجمة عربي
Je promplem trancemition fixe
Typical unreliable rangerover
😊
Slow.
🤷♂️
Just saying, not trying to disrespect what you do. Break down whats the issue first then tell us how you came to the conclusion with the break down. Good vid tho.
I did all that any way...