Nice build! 👍🏽 Liked and Subscribed. I’m currently building the exact frame. What do you think about using the Flywoo Robo 1202.5 11000kv motors on 2S? Thanks. Also in the adjustments tab I learned that you can assign a switch to change your rate profiles, a 3 position switch preferably. Again, Nice Job with the detailed video. I like the LEDs you have on there too. 👍🏽
Thanks! I think those motors would work well too. A bit on the lower kV side for my liking, but I think it would run a bit cooler and have a bit more torque than the 1003 that I used (based on the stator volume calculations, the 1202.5 has a larger volume than 1003). Nice! Thanks for the tip regarding rate profiles on a switch, but I use the Jumper T-Lite and have all my switches used up already. Maybe when I upgrade my controller 🤔 Thanks again for the comment 👍
Yep. It has the ICM 42688 gryo. I haven't had any issues with it, but then again I'm not a precision pilot like a competition racer or anything. Flies well for freestyle for me
There's a 4.5v pad next to the SBUS pad (which is also next to UART1 pads). That should provide power when the USB is plugged in. Use that to power the receiver and GPS
@@ko1n570 yep. That's correct. Components that have 5v input specified (such as receivers and GPS) actually can take a slightly lower voltage input such as 4.5v.
Nice build! 👍🏽
Liked and Subscribed.
I’m currently building the exact frame. What do you think about using the Flywoo Robo 1202.5 11000kv motors on 2S? Thanks.
Also in the adjustments tab I learned that you can assign a switch to change your rate profiles, a 3 position switch preferably. Again, Nice Job with the detailed video. I like the LEDs you have on there too. 👍🏽
Thanks! I think those motors would work well too. A bit on the lower kV side for my liking, but I think it would run a bit cooler and have a bit more torque than the 1003 that I used (based on the stator volume calculations, the 1202.5 has a larger volume than 1003). Nice! Thanks for the tip regarding rate profiles on a switch, but I use the Jumper T-Lite and have all my switches used up already. Maybe when I upgrade my controller 🤔 Thanks again for the comment 👍
Very nice build!!!
btw does it have icm gyro? if yes how does it perform?
Yep. It has the ICM 42688 gryo. I haven't had any issues with it, but then again I'm not a precision pilot like a competition racer or anything. Flies well for freestyle for me
Have any problems in low voltages with this AIO?
No. Not yet with the 2S batteries I've been using
hey i have the same board. if i plug on micro usb it didnt turn on my rx and gps. how to make it turn on my gps and rx when i plug micro usb ?
There's a 4.5v pad next to the SBUS pad (which is also next to UART1 pads). That should provide power when the USB is plugged in. Use that to power the receiver and GPS
@@nxp200 1 pad for rx and gps ?
@@ko1n570 yes
@@nxp200 gps spec it say power input 5v. we can put it in 4.5v ?
@@ko1n570 yep. That's correct. Components that have 5v input specified (such as receivers and GPS) actually can take a slightly lower voltage input such as 4.5v.