Here's a link to the stuff I buy! Chipboard as well as other book binding stuff : www.amazon.com/shop/pink_monarch_prints/list/24SMNLWL8FYJK?ref_=cm_sw_r_cp_ud_aipsflist_37KAZABBFG4ZQAV71PE4 (It looks like it's also on sale today!)
I struggled with the measurements for the side pockets. It seemed I needed to change them in order to made the three pockets. Anyone else? Or are there corrected measurements I should know about? TIA for the help.
I used 1 1/2'', 3 1/16'', 5 3/4'' and 7 1/3... too bad I had to figure it out by myself after having made my score lines with the measurements in the video... :(
It looks like you are using Uhu stick glue, right? I tried using it to glue two prints I had downloaded and printed from one of your kits. I pressed it for several hours a pile of books. But it curled right up tighter than a matron’s pincurl. What am I doing wrong?
Am I the only one who had trouble with the "door knob" closure on this particular kit? I do not have Bingo chips like you used and ended up with a mess. NOTE: I deleted all my ranting! I have finally decided that I will just forgo the "door knobs" and tie a piece of ribbon or jute around it instead.
So cute!!❤
Oh I really like this one!!! Thanks
Lovely project!
love it!!!! will have to get these SS ! xo
Where can I find
Chip board
I’m not even sure what it is, but it looks really thick
Here's a link to the stuff I buy! Chipboard as well as other book binding stuff : www.amazon.com/shop/pink_monarch_prints/list/24SMNLWL8FYJK?ref_=cm_sw_r_cp_ud_aipsflist_37KAZABBFG4ZQAV71PE4 (It looks like it's also on sale today!)
I struggled with the measurements for the side pockets. It seemed I needed to change them in order to made the three pockets. Anyone else? Or are there corrected measurements I should know about? TIA for the help.
Yes, measurements were not acurate..... figured it out pretty quickly..... but, a little frustrating at first!
I had to also change the measurements bro get pockets that looked like the sample.
@@tassiehare1004what are the correct measurements! Help!
@@lorrainevazquez6727 I used 7 1/8" instead of 7 5/8" for the top measurement and it worked pretty good.
I used 1 1/2'', 3 1/16'', 5 3/4'' and 7 1/3... too bad I had to figure it out by myself after having made my score lines with the measurements in the video... :(
It looks like you are using Uhu stick glue, right? I tried using it to glue two prints I had downloaded and printed from one of your kits. I pressed it for several hours a pile of books. But it curled right up tighter than a matron’s pincurl. What am I doing wrong?
Am I the only one who had trouble with the "door knob" closure on this particular kit? I do not have Bingo chips like you used and ended up with a mess. NOTE: I deleted all my ranting! I have finally decided that I will just forgo the "door knobs" and tie a piece of ribbon or jute around it instead.