2 DOF Motion Simulator Build. Motor Preparation
Вставка
- Опубліковано 6 жов 2024
- this video is about to prep DC motor for my future seat mover, using SMC 3 firmware for arduino uno and BTS7960 for motor driver..
dont forget to like and subscribe
and stay tuned for my next build video...
thanks...
Mantap bang....
Di tunggu episode selanjutnya....👍👌
Thanks Zaenal. I have quite a few more episodes out now.. Dave
What car engine do you recommend?
potentiometer value?
Hello, I have a 40 watts wiper motor from VW Golf and want to build a seat mover, can 40 watts do it.
maybe not.. I did a whole series on my channel about using WW motors.. check it if you have time my friend.. DMAX
@@DMAX_DIY I already bought 2 (PGSaw 200 watt) motors :)
@@pawestrzop1037 Ok.. Those should be way better than WW motors. I have PGSaw motors on my 3DOF. Do you know the voltage and gear ratio for those one's you have?
@@DMAX_DIY info
12V DC power supply power 200W
No-load speed: 3600 RPM with 25: 1 reduction
RPM under load: 2750 RPM with 25: 1 reduction
no-load current: 1.6A
current under load: 23.8A
engine torque 0.63 Nm
motor torque after the transmission 15.75 Nm
revolutions 110 rpm with load after reduction
weight 3 kg
work type S2
@@pawestrzop1037 Ok @Paweł Strzop Those are fantastic motor 'stats'.. Yeah the PGSaw motors are the better choice .. I use a 12V 850 amp battery on my 3DOF.. But the most I've actually measured while driving hard brake to full acceleration is around 27amps. That was ALL three motors live action.. Mine idles around 3 amps before telemetry. Hope that helps you out..
Untuk tiang dri motor nya namanya apa mas?
What is the voltage off of that battery please ?
hey Jack.. Battery voltage is always 12V.. I did a series on this on my ch.. Not trying to stomp on his video. but just saying 12v is the battery voltage for WW motors. DMAX