Hi Devin, looks great. I am getting ready to install two of the exact same windows in my Transit. I know you were asked about how you trimmed out the interior, but I don't see an answer. Did you leave the metal edge exposed? Did you come up with a good way to make the interior look nice?
I did not cover the cut edge but they make a gasket to cover it when you buy the window. I trimmed mine out in wood. I have sold the van and moved on from van life. Thanks for watching!
This window was a bit easier to install than the CRL window. It only requires glue and followed the factory stamp. Just make sure you buy the caulking gun they offer because the glue is very thick and is very difficult to squeeze out if you don’t have the right one and it will dry by the time you set the window and it’s ruined. I
well done. I just want my sliding forwards not back on left side window. I wonder if I can get one like that
Hi Devin, looks great. I am getting ready to install two of the exact same windows in my Transit. I know you were asked about how you trimmed out the interior, but I don't see an answer. Did you leave the metal edge exposed? Did you come up with a good way to make the interior look nice?
I did not cover the cut edge but they make a gasket to cover it when you buy the window. I trimmed mine out in wood. I have sold the van and moved on from van life. Thanks for watching!
Superb job guys - what a great look. How much are the side windows and where from?
They were a few hundred bucks like $300 I believe. VWD
Looks good bud,did you put trim on the inside? Thanks
This window was a bit easier to install than the CRL window. It only requires glue and followed the factory stamp. Just make sure you buy the caulking gun they offer because the glue is very thick and is very difficult to squeeze out if you don’t have the right one and it will dry by the time you set the window and it’s ruined. I
@@devinagee1923 I’m going to put the glue tube in Hot water for a while to soften it and will just make sure as you say measure twice 😁
@@bazailzb4737 I’d highly recommend just getting the caulk gun. I don’t think hot water is a good way to go. But hey! You do you!
I need your your help
You got this! Not too bad!
Hey hey what's the window called that u used???
Van Windows direct. It was in the clearance section.
Isn't the primer needed to be applied in 1 way round?
Been installed almost a year with 0 issues