GSXR Fork Conversion - Suzuki GS750 (cognito moto kit)

Using the Cognito Moto kit to finalise the GSXR front end swap on the 1978 Suzuki GS750
Link for SV650 parts: pic-metalworks...
My shop: www.younggunsg...
Instagram: / pic__metalworks
Contact: [e-mail]

[@esen1058]

This is looking great. Subscribed. I've done my gs750 as a cafe racer and always wondered about doing the front end swap. Keen to see how it turns out.

[@timhorsley7367]

So sick Benj! Always look forward to your uploads

[@Benji...]

Thank you bro!

[@wayne3340]

I can see in your video, there are three slots around the upper race. Put a chisel in there at an angle and break the outer race in pieces.

[@mario_on_e-odin2.0]

I have never do this so sorry for my dumb question - what is that conversion stem kit for ? To get front part higher ? If not could you use original stem (with proper bearings) ? Thank you. Subscribed.

[@Benji...]

you may be able to just use conversion bearings I'm not sure

[@jakeanico9642]

What size is the front axle rod on this one?

[@Benji...]

25mm

[@user-hi7im4pi1f]

What size is top bearing

[@jeremypena8935]

Will gsxr front end will fit my 78 xs750?

[@Benji...]

Sorry i don’t really know those bikes bust i’m sure it would, just need to find the right conversion kit or bearings needed

[@thefacilitysportstv8127]

How long is the conversion kit stem? Looking to do the same on a gsx1100g

[@Benji...]

It's quite long, longer than the GSXR stem and I had to use a few spacers on the bottom as you can see in the video

[@thefacilitysportstv8127]

@@Benji... thanks for the response!
That’s good to know, I was worried it could be too short, sounds like it’ll work

[@bbob5050]

Dude hurry up with the cb videos