Good video have you done or could you do a video of the process for making a back gutter I assume it’s similar but slightly different because you’re gonna have to drop
I just wondered why you didn’t make that apron deeper on the front so that you can then just tuck it straight into your chase line. I guess ur gonna fit that and then make a separate cover flashing to go over the front of that? Interesting, I’ve never seen it done like that before. I respect the way you are doing your aprons but I personally don’t feel it necessary to weld aprons when a minimal amount of lead material bossed around the corners is sufficient to accept either soakers or lead cover flashings. Nevertheless, nice job and nice little video. Thank you.
Nice demonstrated video mate, been on a lead welding course and it’s hard to remember everything so this is a good refresher,
Why did you not use a thinner width of lead rather than cut some off?
Good video have you done or could you do a video of the process for making a back gutter I assume it’s similar but slightly different because you’re gonna have to drop
Face protection pls
Hi what welding set do you use
nice vid how long does the gas and oxy last on that set up thanks
I just wondered why you didn’t make that apron deeper on the front so that you can then just tuck it straight into your chase line. I guess ur gonna fit that and then make a separate cover flashing to go over the front of that? Interesting, I’ve never seen it done like that before. I respect the way you are doing your aprons but I personally don’t feel it necessary to weld aprons when a minimal amount of lead material bossed around the corners is sufficient to accept either soakers or lead cover flashings. Nevertheless, nice job and nice little video. Thank you.
Cómo se llama ese material
Minimum 90mm upstand