Це відео не доступне.
Перепрошуємо.

Honda ATV Heated Handgrips TRX 520 / 420 How to install heated handgrips

Поділитися
Вставка
  • Опубліковано 17 сер 2024
  • In this one I install the Honda Signature accessories brand heated handgrips onto the Honda TRX 520 Rubicon this install procedure will also be the same for the 420 and the 520 foreman if you have any questions leave them in the comments below thank you for watching

КОМЕНТАРІ • 30

  • @weekender38
    @weekender38 4 місяці тому

    Very nice job on the installation and explanation.

    • @Maxsmotoshop
      @Maxsmotoshop  4 місяці тому

      Thank you I hope you found it very helpful😎

  • @robertkennedy4693
    @robertkennedy4693 Рік тому

    Thanks for the vid, and the music is just fine.

  • @gunflintexplorer7071
    @gunflintexplorer7071 Рік тому

    Thanks for the video and posting the part #s.

  • @markbuck9299
    @markbuck9299 Рік тому +1

    Looks like the Heat Demon setup

  • @Cd55650
    @Cd55650 Місяць тому

    Can you run any grip on these you want after these wear out? I love my ODI lock on grips for my bikes so ideally I would want to slide those on over these

  • @gillt1975
    @gillt1975 Рік тому

    Great video! Thanks

  • @timking2194
    @timking2194 2 роки тому

    I installed these they really get hot

  • @user-zd8ou6vu8m
    @user-zd8ou6vu8m 2 роки тому

    Nice job!

  • @jamescooksey2885
    @jamescooksey2885 9 місяців тому

    Will i still have the plave to instal the additional harness if i dont have the power outlet?

  • @CIOZ3075
    @CIOZ3075 2 роки тому +1

    Any idea if you can wire winch and hand warmers into that same accessory wire adapter?

    • @Maxsmotoshop
      @Maxsmotoshop  2 роки тому

      Yes you can that is what the sub harnesses made for👍

  • @vincenzoizzi5407
    @vincenzoizzi5407 2 роки тому

    love your videos... i have the 520 with the same grip heater... but i noticed that you made the same mistake as my dealer.... you put the grips on the wrong sides... the "honda" logo on the grips are supposed to be on the top side. not at the bottom

    • @Maxsmotoshop
      @Maxsmotoshop  2 роки тому +2

      LOL good call I’ll remember that for now on👍

  • @loveistheanswer8137
    @loveistheanswer8137 2 роки тому +1

    I find the music distracting. Could you not just overdub a description as you go if it is sped up. I enjoy the content, the music not so much.

  • @kieranhegarty3138
    @kieranhegarty3138 2 роки тому

    Hi nice job do u have the link where I can order these from.

    • @Maxsmotoshop
      @Maxsmotoshop  2 роки тому

      Check out the Honda ATV website under accessories

  • @I-Noses
    @I-Noses 10 місяців тому

    Do you have a part number for the second sub harness?

    • @Maxsmotoshop
      @Maxsmotoshop  10 місяців тому

      Watch the first 10 seconds of the video

    • @I-Noses
      @I-Noses 10 місяців тому

      You mention installing two sub harnesses. The first 10 seconds shows 1 sub harness part number. Is there 2 in that bag?

    • @I-Noses
      @I-Noses 10 місяців тому

      Same part number on my box but no sub harness in the box😢
      Confusion over, thanks

    • @theradiation7420
      @theradiation7420 Місяць тому

      @@I-Nosesmaybe it was in the rubber boot?

  • @user-lv8is3xt8x
    @user-lv8is3xt8x 8 місяців тому

    How long did this take to install ?

    • @Maxsmotoshop
      @Maxsmotoshop  8 місяців тому

      I am very experienced can do it in about half an hour without experience about an hour and a half

  • @jonkastanek2468
    @jonkastanek2468 2 роки тому

    Is that hard have enough power or is it kind of a turd

    • @Maxsmotoshop
      @Maxsmotoshop  2 роки тому

      Yes it has enough power for the Handgrips along with other accessories👍

    • @jonkastanek2468
      @jonkastanek2468 2 роки тому

      Does the motor have a lot of power

    • @Maxsmotoshop
      @Maxsmotoshop  2 роки тому +1

      Yes