Install Bed Distance Sensor,Open box

[@bigdumbanimal23]

Can you please show the correct pin outs to connect to the 4.2.7 board. You go too fast through that section.

[@DiscoverySky]

Hi, here is the image of connection github.com/markniu/Bed_Distance_sensor/wiki/Installing-Bed-Distance-Sensor#example and it should be better to remove that white plastic of that socket since the height of the pins on the board is a little short

[@kevinsanchez4272]

will the sensor turn off after layer 2? im afraid the sensor will continue to operate and adjust off the print. If the print is bad, the sensor will go off the print making the print worse

[@DiscoverySky]

yes, the operate layers can be setted by adding one gcode in the print file

[@manuelchaves6835]

Please post the sale link.

[@DiscoverySky]

Hello, here is the link www.pandapi3d.com/product-page/bed-distance-sensor

[@thedeadbuzzard]

How well does this hold up with printing high heat filaments and in an enclosure?
I as well am eager for klipper support too

[@DiscoverySky]

The coil of the sensor is in the high temperature resistance AB glue and nylon print case😀

[@_MicZ_]

@@DiscoverySky That doesn't mean the sensor will have the same accuracy at higher temperatures, it just means the housing will not melt.
Also: I'd be worried about the double sided tape with which the sensor is mounted, both in normal and high temperature scenarios ...

[@kevinsanchez4272]

@@_MicZ_ I agree, it would be nice to know what the max temp is while maintaining the accuracy

[@MrWaalkman]

Thank you so much!

[@ivanp747]

Hello, it will also be available for klipper?

[@DiscoverySky]

Not yet, that would require some software work on the klipper side.

[@DiscoverySky]

Here is the beta version of Klipper that support Bed Distance Sensor
github.com/markniu/Bed_Distance_sensor/wiki/Installing-for-Klipper