Installing the SRX2 Steps on the 2021 Ford Bronco

Поділитися
Вставка
  • Опубліковано 3 жов 2024
  • Here's Gaston to demonstrate the ease of installing Rough Country's new SRX2 Side Steps. Constructed with an innovative slotted rail system, our cast aluminum hoop steps are easily adjustable. Just slide the footpad left or right along the rail until it is at the perfect position to hop in and out.
    Get yours: www.roughcount...

КОМЕНТАРІ • 13

  • @vickieryer694
    @vickieryer694 2 роки тому +2

    I ordered these steps for my Bronco. Love them, however, the video would of been better without the background beats. It was hard to hear what you were saying when you were bolting them to the vehicle. Very annoying lol

  • @Faceless_XIV
    @Faceless_XIV 3 місяці тому

    They sit so damn low that it takes a huge bite out of your ride height. Absolutely pointless unless you’ve got a 10” lift.

  • @lawgreen1924
    @lawgreen1924 6 місяців тому

    Good steps but they are 6 lock nuts short on my truck. 2018 chevy 2500. Had to take off the nuts from the bottom of the steps to accommodate the mounting. If you count all the holes its 18 nuts per side.

  • @ivanhamlyn
    @ivanhamlyn 5 місяців тому

    Are the brakets universal or vehicle specific??

  • @evanimdorf5380
    @evanimdorf5380 2 роки тому +1

    Is their a difference in height between the SR2 and SRX2 steps, when is this coming out in a 2 door version for the Bronco

  • @JonathanGolden-f1o
    @JonathanGolden-f1o 6 місяців тому +1

    Trying to install this on my bronco and the nuts don’t fit in the slots unfortunately

  • @botchman5947
    @botchman5947 Рік тому

    If u bought the ford rock rail donu have to remove for steps?

  • @Brian-cm7iz
    @Brian-cm7iz 2 роки тому

    Where did you get the bronco emblem that under your side mirrors

  • @mikem8093
    @mikem8093 2 роки тому

    Nice

  • @NoNo_Notlikethat
    @NoNo_Notlikethat 2 роки тому

    I like the look of these, and that the steps seem removable from the rails.
    I just don't know if I trust T-nuts into extrusion to hold my big ass. What's the expected weight limit on one of the steps?