Thank you for this! For the amount of money we spend on a wavy and can you would think their engineers would figure this shit out. What a joke. Again thank you this really helped me.
@@jamescoad7174 you’re welcome! I think the driving force of this dumb design is regulations. In an effort to reduce gas emissions, they came up with the design that ends up spilling more gas.
I thought these cans would be awesome, 2 years later, the spout plastic broke and parts of it fell into my gas tank, now the bottom seam started leaking gas. Going to buy more plastic cans like one that's been sitting behind my garage for 10 years and is still doing fine.
The collar doesn't slide down when attached, even with a lot of force. Now what? (Edited). I really pushed on it, and it moved. Thank you for this video.
I was looking for this hack. I thought the leakage was coming from where the metal meets the plastic sine it is only spot welded but I will try this and let you know. Thanks for the video and God bless.
Thank you for this! For the amount of money we spend on a wavy and can you would think their engineers would figure this shit out. What a joke. Again thank you this really helped me.
@@jamescoad7174 you’re welcome! I think the driving force of this dumb design is regulations. In an effort to reduce gas emissions, they came up with the design that ends up spilling more gas.
Thanks for the video. Awesome hack!
I thought these cans would be awesome, 2 years later, the spout plastic broke and parts of it fell into my gas tank, now the bottom seam started leaking gas. Going to buy more plastic cans like one that's been sitting behind my garage for 10 years and is still doing fine.
Thanks for that tip.
Thx for the post!
Great tip! Do you happen to have a link where we can buy the OJ nozzle (the one in your video)?
sure! here.
a.co/d/adi4LU8
nice thinking… appreciate the hack… Stay blessed
Thanks Cuz!
The collar doesn't slide down when attached, even with a lot of force. Now what? (Edited). I really pushed on it, and it moved. Thank you for this video.
I was looking for this hack. I thought the leakage was coming from where the metal meets the plastic sine it is only spot welded but I will try this and let you know. Thanks for the video and God bless.
good luck!
They must have changed the design…..I can’t get it off after I remove the screw
sometimes it gets stuck. try wiggling it or twisting it side to side after you get the screw out.
@@expeditionaryfamily thanks man…..yeah…..I used a rubber mallet to bang it and it moved…
Appreciate it