Hi My cbr 125 2012 has a issue when im riding and fully open the throttle the acceleration is very slow but once it hits 8k+ revs the bikes speed starts to kicks in abit , and as u let of the throttle the revs come down very slow. When i rev the bike in netrual the revs up up fine and come down fine. Iv changed the fuel pump , air filter , fuel filter , o2 sensore signal wire, and iv changed the whole throttle body
@solarisguitar121 by inserting wire in the red dlc block and holding full throttle and turning bike on for few secs while the mil blinks then turn off ignition is that reseting the ecu ?
@solarisguitar121 just above your rear wheel on top of mudguard there's a cover you take off and it's right there. Basicly your rear tail light wiring harness its on there
Does unpluging the o2 sesnor being up engine management light to come on ?
My guyyyyyyyyy thabk you
What about cleaning it with a mass airflow sensor or throttle cleaner?
Hi My cbr 125 2012 has a issue when im riding and fully open the throttle the acceleration is very slow but once it hits 8k+ revs the bikes speed starts to kicks in abit , and as u let of the throttle the revs come down very slow. When i rev the bike in netrual the revs up up fine and come down fine. Iv changed the fuel pump , air filter , fuel filter , o2 sensore signal wire, and iv changed the whole throttle body
you reset ecu?
@solarisguitar121 by inserting wire in the red dlc block and holding full throttle and turning bike on for few secs while the mil blinks then turn off ignition is that reseting the ecu ?
@@jasoncarthew2279 yes but i can’t find the red block i have same bike as you where is it?
@solarisguitar121 just above your rear wheel on top of mudguard there's a cover you take off and it's right there. Basicly your rear tail light wiring harness its on there
@@SCXRRR488 you find it ?