VW Golf 5 airbag no communication problem 00532 fault
Вставка
- Опубліковано 8 сер 2019
- later I realized that the mistake was caused earlier by the B + exceeded. bad ground lighted airbag light, could not load ecu. after the ECU was screwed on the car, the airbag disappeared and no more error was reported.
fault code 00532 Supply voltage B+ 002 lower limit exceeded intermittent
01321 fault J234 control module for Airbags No Signal/Communication
00446 fault function limitation due to under voltage
airbag light stay ON
VW SEAT SKODA AUDI Airbag ecu fault
#VWAirbagreset
VW Airbag light reset - Авто та транспорт
later I realized that the mistake was caused earlier by the B + exceeded. bad ground lighted airbag light, could not load ecu. after the ECU was screwed on the car, the airbag disappeared and no more error was reported.
You are lucky guy doing this without disconnecting a battery)
Haaaa thanks bro❤
The ecu showed no communication in this video because it was not bolted down.
So the principal sensor is the prolem
Was this a bad ground ?
Apparently the airbag module uses all three nuts as ground contact points, if one isn't grounding properly you can lose communication with the module. The modules can also suffer from water damage so I guess check if ground is ok then if it's still not working get a replacement with the same coding (numbers on label match with old unit) so it's a straight swap.
Remember to always disconnect the battery and wait 30 mins before messing with anything to do with airbags.
.... you bought a new watch ?
I got that from my uncle 20 years ago.
Nemaš ti pojma, ne brukaj se ! ! !