Thanks man for this video, i have a 2011 charger and my master switch was broken. The Dodge wanted to charge me $412 to replace both driver and passenger😡,but watching your video empowered me to do it myself and saved $322. Your video was very helpful, Thanks man👌🏿💪🏿
Thanks great tips. In the future. Before you put the new parts into the old bracket. Plug it in to test before you pop it out of the unwanted bracket. Then unplug, and swap them out. It'll save you some extra time and effort
Thank you for the video man! The only part I was sketchy about was taking it out of the door. Once I got that done I was great, even took a picture. The reset is the same in the 2010 manual as well (2 sec.) Mine only has an auto down function though. I was messing with it and even double checked my old one to see if it ACTUALLY did work, thankfully/sadly it didn't. Took me 30 minutes from the time I got out of bed till I commented.
The only issue I have is my driver side window not going down. Every other window works perfectly. I've switched out the fuses as well. Still can't get the window to go down. I'll give this a shot though.
Awesome. Ok well I followed all the steps. I’m at the point where I need a new replacement one. Buttttt before I go and buy one just wanted to make sure that that would fix it? Because it’s only one window (passenger) neither the passenger button works on either door. At first it wouldn’t go up it would only go down. Yesterday I finally put it down all the way and it just didn’t want to go back up. So idk if it’s the window it’self or should I still just go ahead and get another little window motor
Sorry for the delay. I have experienced that problem below. If you can get the window to go down, but it struggle to go up, the problem may be with the window and/or motor not necessarily the switch. My issue was resolved by cleaning the inside and outside of the glass. Worked for me but I’m not sure it will be a permanent fix.
Hopefully this works in my avenger. I've had an issue with the switches for down time now. But they began working again and then the front passenger stopped working out of the blue.
great video I hope this works because some thieves just wanted to charge me almost 400 plus 102.00 to diagnose. pray to dear jesus this works when i get the part from ebay. Thank you. great job explaining.
I pulled mine out the driver's switch went out. All you have to do is take it apart pull the switches up hard and they pop right out. its little pins that goes in the holes of the board just switch them around until you can get a new one. Remember take it completely apart until there's nothing but a green chip and switches
@@thewordens3965 ok thanks so much for the fast response! Only one button isn't working on my switch so I don't think my problem is the same as yours. (Well at least I hope not..lol)
I did exactly this. This video is good but probably you don't need to replace the switch. Try simply disconnecting your battery first, for just a minute.That's all mine needed. When he first tested the switch, it still didn't work and there's an edit. He obviously found some information he didn't share.
Daniel - Thanks for the comment. What I did not include was randomly pulling out and reinstalling a few fuses. Unfortunately, there is not a specific fuse for the window switch. We would recommend trying that first.
I just happened to receive the reply right as you wrote it! Like I said- he shows you how to replace the switch very well. But if you're about to replace the switch, and the passenger window works from its control, save yourself some trouble by doing what I suggest. You probably don't need the new switch.
Both of my front windows won’t go down unless if I disconnect the battery and it’ll last only a few days then stop working again. Anybody know if this would fix? Before I buy the part and give it a try
No one should be pulling the window switch out from a top with a screwdriver tearing up your interior. That drives me crazy and no 1 has a video where you take it out from the bottom. I don't want to mess up my interior . Got mine out from the bottom
Thank you for the video. You saved me $345. I bought the part followed your instructions & I was done in 10 minutes.
ajust916 that’s awesome... glad it was helpful!
Thanks man for this video, i have a 2011 charger and my master switch was broken. The Dodge wanted to charge me $412 to replace both driver and passenger😡,but watching your video empowered me to do it myself and saved $322. Your video was very helpful, Thanks man👌🏿💪🏿
YourMammas AssCrack 9000 I believe it is.
I replaced the part myself for $24.00 and saved over $200.00 Thank you for the video.
pamela jennings you’re welcome. Glad it worked out.
Thanks great tips.
In the future. Before you put the new parts into the old bracket. Plug it in to test before you pop it out of the unwanted bracket. Then unplug, and swap them out. It'll save you some extra time and effort
Thank you for the video man! The only part I was sketchy about was taking it out of the door. Once I got that done I was great, even took a picture. The reset is the same in the 2010 manual as well (2 sec.) Mine only has an auto down function though. I was messing with it and even double checked my old one to see if it ACTUALLY did work, thankfully/sadly it didn't. Took me 30 minutes from the time I got out of bed till I commented.
The only issue I have is my driver side window not going down. Every other window works perfectly. I've switched out the fuses as well. Still can't get the window to go down. I'll give this a shot though.
What was the problem?
u figure it out?
Same issues I’m having rn
Could be the switch.
Curious if you ever fixed it. Same problem I'm having now.
Awesome. Ok well I followed all the steps. I’m at the point where I need a new replacement one. Buttttt before I go and buy one just wanted to make sure that that would fix it? Because it’s only one window (passenger) neither the passenger button works on either door. At first it wouldn’t go up it would only go down. Yesterday I finally put it down all the way and it just didn’t want to go back up. So idk if it’s the window it’self or should I still just go ahead and get another little window motor
Sorry for the delay. I have experienced that problem below. If you can get the window to go down, but it struggle to go up, the problem may be with the window and/or motor not necessarily the switch. My issue was resolved by cleaning the inside and outside of the glass. Worked for me but I’m not sure it will be a permanent fix.
Thanks for the video! Was able to fix my switch on the Challenger my wires were a bit short so it was annoying to connect the switch
Amazing! Thank you! (I don't have a Charger. I have a Challenger but this helps me understand how the switch works)
Thank you for this video, this saved me a lot of cash just by doing it yourself
Hopefully this works in my avenger. I've had an issue with the switches for down time now. But they began working again and then the front passenger stopped working out of the blue.
Good video should work on my 2013 200 also. Just digging out the panel is a pain at lest I seen WHERE the clips are thanks
great video I hope this works because some thieves just wanted to charge me almost 400 plus 102.00 to diagnose. pray to dear jesus this works when i get the part from ebay. Thank you. great job explaining.
Lauren Rozakis me too!!
Excellent video, you just saved me a lot of precious time!! Kudos!
Howard Johnston you’re welcome! Thank you
THANKS & Aces Great video I was able to fix in less than 5 min - took longer to find right one on Ebay
Jim Carney that’s awesome!
I’m tearing apart the door on my 2009 Avenger SXT right now because you can’t take the window control out like your video states FYI
Thank you for the video! Clutch!
Do you know if the master control it's similar with others dodge models?
I believe it is. The control I used for this was taken out of a Jeep.
Thank you I appreciate the video
Is it the same for the passenger side
Same process. Disconnect and reconnect car battery first to troubleshoot. If that doesn’t work, proceed with the steps in video. Good luck!
I pulled mine out the driver's switch went out. All you have to do is take it apart pull the switches up hard and they pop right out. its little pins that goes in the holes of the board just switch them around until you can get a new one. Remember take it completely apart until there's nothing but a green chip and switches
Works to for Chrysler 200?
Very informative thanks
I cant replace mine because the wires arent long enough to flip it upside down and unclip
All of my windows on 2010 sxt stopped working suddenly. Have tried each switch in the car none work. Anyone have a clue what to do?
Game Over try disconnecting the battery and reconnecting after 5 mins
Or maybe a fuse
Can I do the same thing for my challenger
JB TV I believe so. Should be similar
FreedomFighter07 Thanks! I’ll try it out tomorrow
@@thewordens3965 hello. Did it work? I have a challenger as well
E. Marie Not for me I ended up replacing the door lock actuator that fixed all of my problems. My window used to go up and down by itself
@@thewordens3965 ok thanks so much for the fast response! Only one button isn't working on my switch so I don't think my problem is the same as yours. (Well at least I hope not..lol)
Mine you have to remove it from the bottom mine is not a 2 piece mold!
Can you please explain why it didnt work on your first try? I have same issue, and did exactly the replacement you did. Otherwise an excellent video.
Hey did you figure out why it didn't work ?
Sorry for the delay. For those wondering. I disconnected unit and reconnected. I also then disconnected the battery.
It helped me
@FreedomFighter07 was your problem that the window wouldn't go down or wouldn't go up?
Jason Cherry neither up or down
Great job , thank you !!!
Well just watched this video after I paid my mechanic 300 to replace the switch. Kinda hate myself now lol
Thanks a million!
Wait why didn't it work when you tried it the first time? Anyone know?
Nonchalant Bastard honestly not sure. But try discounting the switch again and plugged it back in. Do same with battery.
I think it's because the car wasn't on.
What if it doesn't work
How do I just tighten it up so it does not shake when I play music n car??????
I did exactly this. This video is good but probably you don't need to replace the switch. Try simply disconnecting your battery first, for just a minute.That's all mine needed. When he first tested the switch, it still didn't work and there's an edit. He obviously found some information he didn't share.
Daniel - Thanks for the comment. What I did not include was randomly pulling out and reinstalling a few fuses. Unfortunately, there is not a specific fuse for the window switch. We would recommend trying that first.
no. it was that the car was not on when he tried.
I just happened to receive the reply right as you wrote it! Like I said- he shows you how to replace the switch very well. But if you're about to replace the switch, and the passenger window works from its control, save yourself some trouble by doing what I suggest. You probably don't need the new switch.
@@teledan105 do u mean that the car baterry needs to be removed and put back?
Both of my front windows won’t go down unless if I disconnect the battery and it’ll last only a few days then stop working again. Anybody know if this would fix? Before I buy the part and give it a try
How on earth did you get to the point when the video starts?????
Use a screwdriver to pop it out.
Get to the point
No one should be pulling the window switch out from a top with a screwdriver tearing up your interior. That drives me crazy and no 1 has a video where you take it out from the bottom. I don't want to mess up my interior . Got mine out from the bottom