Christian, I really appreciate your videos. Just a note, you stated that in single line text that you can't add symbols/special characters. It should be noted that you can add special characters, you just have to type them in as code. such as %%D for degree, %%C for diameter, or \U+2220 for angle.
At the 3:00 minute mark, you say that the single line text tool cannot add special character, but I went ahead and tried unicode special characters and was able to get that degree symbol. With alt 0176. Will this cause problems? As in, is that single line text tool with a symbol going to mess things up in the long run?
Christian, I really appreciate your videos. Just a note, you stated that in single line text that you can't add symbols/special characters. It should be noted that you can add special characters, you just have to type them in as code. such as %%D for degree, %%C for diameter, or \U+2220 for angle.
+Katherine Wolfgang sorry, didn't realize someone already commented on this
At the 3:00 minute mark, you say that the single line text tool cannot add special character, but I went ahead and tried unicode special characters and was able to get that degree symbol. With alt 0176. Will this cause problems? As in, is that single line text tool with a symbol going to mess things up in the long run?
any training on how i can see the tru fonts on my autocad 15, or how i can install them, it only shows the the basic font, thank you.
gday mate. thanks for those classes its helping me a lot to start learning how all tis works. Your chanel came up to Brazil.
Hi Chris,
please how do i set the height of a text for a drawing without always having to change it when i have to write another text.
Just saw this video, good very good.
Hi Chris, how can you change your mouse and keyboard actions?
***** Thanks for the reply! I'll see if that works.
Why is my text gone when i enter it or tab
+jobien garcia Same for me...
Probably because your scaling is off, it will look like your text is gone but it is actually just really small