I wish I could help you with that info but it was never published that I know of and the local dealer who built a pump dyno didn't even tell us in the field about that stuff. We did use the travel functions or cycle times on boom up to see if it was working properly.
Fault code 14 is disconnection in swing brake solenoid system. You can get this fault if the swing brake prolix switch is in the full time release position. Fault code 23 is front pump pressure sensor sensor system. It can be a bad sensor or a problem with the wiring. Fault code 26 is the engine speed sensor problem. You can check the sensor with an ohm meter. It should show around 3 to 8 ohms resistance between the wire leaks and no continuity between a lead and the body of the sensor. Good Luck on the repairs.
@@منوعات-خ2ب6ت As I recall the pressure sensor is installed on the main control valve at the hose connection from the pump. There is a sensor for each pump and valve section and you will see the wires going into each.
@@منوعات-خ2ب6ت I'm not in the parts business so I can't send parts to you. You should be able to find them somewhere in North Africa or Europe easy enough. Good Luck
Would you know what voltage and current values are sent from the hydraulic pump controller to the TVC solenoid? in each operating mode
I wish I could help you with that info but it was never published that I know of and the local dealer who built a pump dyno didn't even tell us in the field about that stuff. We did use the travel functions or cycle times on boom up to see if it was working properly.
Hello, I want to know the list of fault numbers for the Dash 5 excavator at 14, 23 and 26. Thank you very much
Fault code 14 is disconnection in swing brake solenoid system. You can get this fault if the swing brake prolix switch is in the full time release position.
Fault code 23 is front pump pressure sensor sensor system. It can be a bad sensor or a problem with the wiring.
Fault code 26 is the engine speed sensor problem. You can check the sensor with an ohm meter. It should show around 3 to 8 ohms resistance between the wire leaks and no continuity between a lead and the body of the sensor.
Good Luck on the repairs.
Thank you, dear sir. Where is the code sensor 23 installed❤
How much is the temperature, diesel and speed screen, used, in good condition, can you send me one to Jordan?
@@منوعات-خ2ب6ت As I recall the pressure sensor is installed on the main control valve at the hose connection from the pump. There is a sensor for each pump and valve section and you will see the wires going into each.
@@منوعات-خ2ب6ت I'm not in the parts business so I can't send parts to you. You should be able to find them somewhere in North Africa or Europe easy enough. Good Luck
من اين اتزود جاز
Thank you for subscribing to my channel.
Do you know any diagnostics on cat 311uc thank you
As I recall that monitor panel doesn't have any and you have to plug into the system with the Cat Sys program to view the diagnostics.