Schneider / Conzerv/ Enercon - EM3460 meter Reset method and Auto mode selection method

[@mothukurisivaraj491]

Err 28 code means what other function keys are not working

[@Mr.Monster1995]

Sir EM 3480 review sollunga pls

[@powerblaster275]

Em3480 Trivector meter - it's absolute model

[@Mr.Monster1995]

@@powerblaster275 thank you sir

[@ntcreations1874]

How to check CT ratio in this meter

[@powerblaster275]

Go to Par setup and press down in display show done Y change done N press ENT key ... its programming screen while press down key A.pri ... value show / ct sec should be constant

[@thirusundaravarathan7]

Please share how to set the DM

[@powerblaster275]

Pls refer video already loaded uL setting

[@Vaishu-7-tan]

Our existing conzerv 3460 is setted MD resetting time is 15 min but how to change it to 30 min sir
Recently our energy meter is replaced and MD resetting time is 30 min sir

[@powerblaster275]

Going to full setup and change dm prd -15 or 30

[@Vaishu-7-tan]

@@powerblaster275 during full-setup mode only the auxiliary supply must be connected to smart demand controller sir
Full-setup should be completed before installing the EM3460 sir?

[@Vaishu-7-tan]

Please do one video on full setup if possible sir

[@TheVinaykhandelwal]

Wh shows 000000
How can set the md controller to show
Kwh reading

[@powerblaster275]

First set led in wh parameter and next set intg parameter then press down key display shows intg 0 ( till press down key ) KWh will show

[@TheVinaykhandelwal]

@@powerblaster275 sir my ct ratio is 3200/5 ,I have set primary ct ratio 3200 but there is no parameter to feed secondary current, and I have connected resistance in auxiliary supply ,is it OK

[@TheVinaykhandelwal]

The Dm model 3460 has obsolete, even schneider engineer has refused to give any support ,pls help me in programming

[@praveent849]

How to check device id

[@powerblaster275]

Already video available.... kindly refer Em3460 meter programming video

[@sonukumarmishra6059]

Hindi me bolye