Hi. Sorry to hear about your problem. I hope you have already found a solution. Mine started doing it today after a crash. Please help if you have found any solution. Thank you
I have the exact same problem plus what Banggood had sent had a twisted boom which put the tail motor at an odd angle. I've messed with my controller settings a ton and still can't figure out what's wrong. Current status is trying to get a refund or a replace from Banggood.
A 6G calibration flight should fix this.
What are those blades off of? They are green and not the original could you tell me what they are off of?
I found the solution. It is from the bent feathering shaft. I fixed it and the problem has been solved thanx to advice from @microrcfriend
Nice, thanks. I'll give that a try when it starts warming up here
Hi. Sorry to hear about your problem. I hope you have already found a solution. Mine started doing it today after a crash. Please help if you have found any solution. Thank you
I have the exact same problem plus what Banggood had sent had a twisted boom which put the tail motor at an odd angle. I've messed with my controller settings a ton and still can't figure out what's wrong. Current status is trying to get a refund or a replace from Banggood.
Did you ever find out an answer for this? Mine does the same but on the left servo.
I suspect it's the main board. Got a partial refund from banggood and ordered another xk110. I have not tried it out yet though.
Odd that it's on the left servo though, maybe a servo issue?
David Mitchell my Xk k123 is doing the same on the left servo and I have had it for 2 months and it just started doing it
Try to remove the connector then return it back..may it help
X9d plus you using module multiprotocol??
In 6g mode. Threshold must be not exceed 70%.
It work 100%